Salta al contenuto principale
Aiuto

Versione corrente di: markus weiher ,

Testo:

i've googled the cache of a "crappy paysite"
 
but here is the thing you need:
 
http://www.outdoordistributors.com/pdf/Murray/MURRAY-MODEL-425000X8A-LAWN-TRACTOR-(2003)-PARTS-LIST.pdf
 
and this is the text from thisthe site:
and this is the text from thisthe site:
 
------------------------------------------------------------------
 
"See attached link and go to page 7. It is going to make it quite a bit easier if you take the mower deck off. It will come off by removing some pins at the mounts. Once you have the deck off you will need to push the clutch in to give you enough slack to get the belt off of the engine pulley. If the belt is blocked by a belt guide that is attached solid to the frame you will need to remove the center bolt out of the pulley and slide it down on the crankshaft.Once you have the belt off of the front pulley you will just remove it from the rear pulley and idler."
 
------------------------------------------------------------------
 
i hope this helps

Stato:

open

Post originale di: markus weiher ,

Testo:

i've googled the cache of a "crappy paysite"

but here is the thing you need:

http://www.outdoordistributors.com/pdf/Murray/MURRAY-MODEL-425000X8A-LAWN-TRACTOR-(2003)-PARTS-LIST.pdf

and this is the text from this site:

------------------------------------------------------------------

"See attached link and go to page 7. It is going to make it quite a bit easier if you take the mower deck off. It will come off by removing some pins at the mounts. Once you have the deck off you will need to push the clutch in to give you enough slack to get the belt off of the engine pulley. If the belt is blocked by a belt guide that is attached solid to the frame you will need to remove the center bolt out of the pulley and slide it down on the crankshaft.Once you have the belt off of the front pulley you will just remove it from the rear pulley and idler."

------------------------------------------------------------------

i hope this helps

Stato:

open