Skip to main content
Help

Original post by: Mazdanoob ,

Text:

No drain or spin is usually a broken lid switch . two screws hold the control panel in place, remove and flip the panel up  and away . there will be 1 molex connector with 3 wires going into the top of the washer . disconnect and jumper two wires together using a paper clip bent into a "U". the 3rd wire is green and is a ground. insulate the jumper with electricians tape. do not jumper the ground. test the machine in spin and it should function now . this is only to diagnose the issue as it defeats the safety of spin stopping when the lid is lifted

Stato:

open