(a) Connect the positive (+) lead from the battery to terminal 2
and the negative (–) lead to terminal 1 and check that the motor turns clockwise.
(b) Connect the positive (+) lead from the battery to terminal 1 and the negative (–) lead to terminal 2 and check that the motor turns counterclockwise.
If operation is not as specified, replace the motor.
-
[image|218849|align=left]
+
[image|218849|align=center]
Power Window Motor
Apply battery positive voltage between terminals 5
and 13, check that the power window motor turns.
If does not operate, inspect the wire harness and motor,
then if they are OK, replace the relay.
-
[image|218848|align=left]
+
[image|218848|align=center]
The tail gate control module is located behind the plastic trim (wall) at the left rear of the vehicle. Beside the small compartment and below the rear speaker
11. Rear Wiper Motor (w/ Rear Wiper) (BE–43)
12. Wire Harness
My guess it is either the relay or the motor. check the power first and see what you come up with. [http://forum.ih8mud.com/79-95-toyota-truck-tech/173958-4runner-rear-window-relay-repair.html|Here are] some instructions for the relay, [http://www.yotatech.com/f116/4runner-rear-window-repair-walkthrough-213178/|and here] is what your tailgate looks like being disassembled [http://www.yotatech.com/f116/4runner-rear-window-repair-walkthrough-213178/|and here] is a bit of a walk-through about the rear window repair. Hope this helps, good luck.
Jason, Check this from the manual:"
Symptom: Power window does not work
Check on :
1. Fusible link
2. Circuit breaker OFF
3. WIPER Fuse (BE–11)
4. Power Window and Wiper Relay (BE–74)
5. Power Window Regulator Switch (BE–70)
6. Window Lock Switch (w/o Power Window) (BE–71)
7. Back Door Control Switch (BE–71)
8. Door Lock Detection Switch (BE–72)
9. Back Door Unlock Warning Switch (BE–72)
10. Power Window Motor (BE–73)
POWER WINDOW MOTOR INSPECTION
INSPECT POWER WINDOW MOTOR OPERATION
(a) Connect the positive (+) lead from the battery to terminal 2
and the negative (–) lead to terminal 1 and check that the motor turns clockwise.
(b) Connect the positive (+) lead from the battery to terminal 1 and the negative (–) lead to terminal 2 and check that the motor turns counterclockwise.
If operation is not as specified, replace the motor.
[image|218849|align=left]
Power Window Motor
Apply battery positive voltage between terminals 5
and 13, check that the power window motor turns.
If does not operate, inspect the wire harness and motor,
then if they are OK, replace the relay.
[image|218848|align=left]
The tail gate control module is located behind the plastic trim (wall) at the left rear of the vehicle. Beside the small compartment and below the rear speaker
11. Rear Wiper Motor (w/ Rear Wiper) (BE–43)
12. Wire Harness
My guess it is either the relay or the motor. check the power first and see what you come up with. [http://forum.ih8mud.com/79-95-toyota-truck-tech/173958-4runner-rear-window-relay-repair.html|Here are] some instructions for the relay, [http://www.yotatech.com/f116/4runner-rear-window-repair-walkthrough-213178/|and here] is what your tailgate looks like being disassembled [http://www.yotatech.com/f116/4runner-rear-window-repair-walkthrough-213178/|and here] is a bit of a walk-through about the rear window repair. Hope this helps, good luck.