Salta al contenuto principale
Aiuto

Versione corrente di: oldturkey03 ,

Testo:

stuart, here is what the service manual suggest :
 
Open the oven door as wide as possible.
 
Place an 1/8" pin in the hole on the right and left door hinges, see Figure 2-1,
 
Remove the screws from each side with a Phillips screwdriver.
 
Remove the lock plate from each side, Figure 2-1
 
Raise the oven door up to a broil stop position. In this position, it will be against the 1/8" pin.
 
Grasp the door toward the top on both sides. Lift the door up and out to remove.
 
[image|212626image|212626|align=center]
[image|212626image|212626|align=center]
 
"SERVICING OVEN DOOR
 
1. Lay the oven door on a protected surface with the inner door panel facing down.
 
2. Remove three screws from lower trim.Remove trim piece.
 
3. Slide outer-door glass down to disengage from top trim. Remove.
 
4. Remove three screws from top oven door trim. Remove the two 3/8" nuts from the door handle bracket.
 
5. Lift up and off. This will disengage the side trim as well.
 
6. Remove the oven window pack by removing the 3/8" nuts from the insulation retainer."
 
Hope this helps, good luck.

Stato:

open

Modifica di: oldturkey03 ,

Testo:

stuart, here is what the service manual suggest :
 
Open the oven door as wide as possible.
Place an 1/8" pin in the hole on the right and left door hinges, see Figure 2-1,
Remove the screws from each side with a Phillips screwdriver.
Remove the lock plate from each side, Figure 2-1
Raise the oven door up to a broil stop position. In this position, it will be against the 1/8" pin.
Grasp the door toward the top on both sides. Lift the door up and out to remove.
 
[image|212626]
 
"SERVICING OVEN DOOR
 
1. Lay the oven door on a protected surface with the inner door panel facing down.
 
2. Remove three screws from lower trim.Remove trim piece.
 
3. Slide outer-door glass down to disengage from top trim. Remove.
 
4. Remove three screws from top oven door trim. Remove the two 3/8" nuts from the door handle bracket.
 
5. Lift up and off. This will disengage the side trim as well.
 
6. Remove the oven window pack by removing the 3/8" nuts from the insulation retainer."
 
Hope this helps, good luck.

Stato:

open

Post originale di: oldturkey03 ,

Testo:

stuart, here is what the service manual suggest :

"SERVICING OVEN DOOR

1. Lay the oven door on a protected surface with the inner door panel facing down.

2. Remove three screws from lower trim.Remove trim piece.

3. Slide outer-door glass down to disengage from top trim. Remove.

4. Remove three screws from top oven door trim. Remove the two 3/8" nuts from the door handle bracket.

5. Lift up and off. This will disengage the side trim as well.

6. Remove the oven window pack by removing the 3/8" nuts from the insulation retainer."

Hope this helps, good luck.

Stato:

open