Salta al contenuto principale
Aiuto

Versione corrente di: oldturkey03 (dettagli voto) ,

Titolo:

Touch screen not working after replacing it.

Testo:

I replaced the digitizer and the touch screen still doesn't work. I read the other posts about it, and want to know if it's possible to solder a new "chip" for the digitizer on the logic board? Ribbons are fine, no grease or smudges. Connect is good, I can hear the click. Does it have to be 100% put together to work? If it's raised up a bit, will that effect it? any info on this would be nice.

Dispositivo:

iPod Touch 2nd Generation

Stato:

openclosed
openclosed

Post originale di: Cody ,

Titolo:

Touch screen not working after replacing it.

Testo:

I replaced the digitizer and the touch screen still doesn't work. I read the other posts about it, and want to know if it's possible to solder a new "chip" for the digitizer on the logic board? Ribbons are fine, no grease or smudges. Connect is good, I can hear the click. Does it have to be 100% put together to work? If it's raised up a bit, will that effect it? any info on this would be nice.

Dispositivo:

iPod Touch 2nd Generation

Stato:

open