Introduzione

The side brush helps the Roomba to clean around corners. When the side brush wears out, replacement is needed for this component. All the tools you'll need for this is a simple screwdriver. If your Roomba is dirty, it might also be helpful to clean it first.

Parti

Nessuna parte richiesta.

With the Roomba upside down and turned off, use the Phillip's 02 screwdriver to remove the one 3.5 mm screw from the center of the side-brush. Set the screw aside and pull the brush out.
  • With the Roomba upside down and turned off, use the Phillip's 02 screwdriver to remove the one 3.5 mm screw from the center of the side-brush.

  • Set the screw aside and pull the brush out.

Aggiungi Commento

Unscrew the four screws that hold the bottom panel using the Phillips 02 screwdriver. The screws will not come out of the bottom panel. They were designed to become loose but not be removed. This prevents you from losing them, and prevents the Roomba from sucking them up if they came out during cleaning.
  • Unscrew the four screws that hold the bottom panel using the Phillips 02 screwdriver.

  • The screws will not come out of the bottom panel. They were designed to become loose but not be removed. This prevents you from losing them, and prevents the Roomba from sucking them up if they came out during cleaning.

  • Once you are sure that all the screws have been loosened as much as possible, then lift the bottom panel up off the Roomba.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 3 persone hanno completato questa guida.

Charles Ward

Membro da: 22/01/2015

742 Reputazione

3 Guide realizzate

Team

Cal Poly, Team 19-7, Maness Winter 2015 Membro di Cal Poly, Team 19-7, Maness Winter 2015

CPSU-MANESS-W15S19G7

4 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 3

Ultimi 7 Giorni: 16

Ultimi 30 Giorni: 53

Tutti i Tempi: 1,660