Introduzione

This is an easy way to quickly replace the side wheel of your Roomba. It is slightly more work than the front wheel, which can be found here, but is a straightforward process.

Parti

Nessuna parte richiesta.

Place your Roomba upside-down on a hard surface.
  • Place your Roomba upside-down on a hard surface.

If all you need off is the faceplate, skip all of the screwdriver-based steps, and just remove the dirt bin(step 7) and start from step 11 at the rear.

David Forrest - Replica

While holding the side brush in place, use a Phillips #1 screwdriver to remove the 4.5mm screw from the center of the brush.
  • While holding the side brush in place, use a Phillips #1 screwdriver to remove the 4.5mm screw from the center of the brush.

Aggiungi Commento

Gently pull upwards on the brush to remove it.
  • Gently pull upwards on the brush to remove it.

Aggiungi Commento

Rotate the Roomba upside-down so the bottom is facing towards you.
  • Rotate the Roomba upside-down so the bottom is facing towards you.

Aggiungi Commento

Using a Phillips #2 screwdriver, remove the captive screws that hold the bottom plate in place. Using a Phillips #2 screwdriver, remove the captive screws that hold the bottom plate in place.
  • Using a Phillips #2 screwdriver, remove the captive screws that hold the bottom plate in place.

Aggiungi Commento

Carefully lift the bottom plate.
  • Carefully lift the bottom plate.

  • The battery is only secured in place by the bottom plate, and may fall out once the bottom plate is removed.

Aggiungi Commento

Find the blue wheel at the bottom of the Roomba, and unscrew the three captive screws holding it in place using a Phillips #1 screwdriver. Find the blue wheel at the bottom of the Roomba, and unscrew the three captive screws holding it in place using a Phillips #1 screwdriver. Find the blue wheel at the bottom of the Roomba, and unscrew the three captive screws holding it in place using a Phillips #1 screwdriver.
  • Find the blue wheel at the bottom of the Roomba, and unscrew the three captive screws holding it in place using a Phillips #1 screwdriver.

Aggiungi Commento

Gently lift the wheel to remove. Gently lift the wheel to remove.
  • Gently lift the wheel to remove.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Team

Cal Poly, Team 13-14, Regan Winter 2014 Membro di Cal Poly, Team 13-14, Regan Winter 2014

CPSU-REGAN-W14S13G14

4 Membri

13 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 7

Tutti i Tempi: 817