Introduzione

The Zoom Q3HD is a handy video/audio recording device released in 2010 How to clean the lens from inside

Remove the two screws from the bottom of the device.
  • Remove the two screws from the bottom of the device.

  • Make sure to put your screws in a safe place.

Aggiungi Commento

Flip the device over and remove the four screws bordering the grate of the device.
  • Flip the device over and remove the four screws bordering the grate of the device.

Aggiungi Commento

On the front of the device, slide the battery compartment cover off by pushing inward and sliding downward.
  • On the front of the device, slide the battery compartment cover off by pushing inward and sliding downward.

Aggiungi Commento

Remove the two screws from the lip of the battery compartment.
  • Remove the two screws from the lip of the battery compartment.

Aggiungi Commento

Remove the final screw from the bed of the battery compartment.
  • Remove the final screw from the bed of the battery compartment.

Aggiungi Commento

WARNING: Pieces may become loose when you separate the device in half!
  • WARNING: Pieces may become loose when you separate the device in half!

  • Run the pry tool along the edges of the device to begin separating the device in two halves.

Aggiungi Commento

REMINDER: Pieces may become loose when you separate the device in half! Apply upward pressure to fully separate the device into two halves.
  • REMINDER: Pieces may become loose when you separate the device in half!

  • Apply upward pressure to fully separate the device into two halves.

Aggiungi Commento

WARNING: If you’re not careful with keeping the screen close to the board, you will rip off the ribbon attaching the screen to the circuit board.
  • WARNING: If you’re not careful with keeping the screen close to the board, you will rip off the ribbon attaching the screen to the circuit board.

  • Lift display screen keeping the top half close to the board.

Aggiungi Commento

Gently flip the black clip up attaching the ribbon of the screen to the circuit board.
  • Gently flip the black clip up attaching the ribbon of the screen to the circuit board.

Aggiungi Commento

Gently slide the ribbon from the circuit board, removing the screen.
  • Gently slide the ribbon from the circuit board, removing the screen.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Grace Bently

Membro da: 13/10/2014

4 Reputazione

1 Guida realizzata

Team

Ohio State, Team 1-1, Mccook Fall 2014 Membro di Ohio State, Team 1-1, Mccook Fall 2014

OSU-MCCOOK-F14S1G1

4 Membri

1 Guida realizzata

My zoom q3HD only have the red light turned on when powering up. No display at all. What is happening? How can I claim warranty? I didn't use the device more than a year. Help me

stancalvin - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 5

Tutti i Tempi: 943