Turn the device over with its display down.
  • Turn the device over with its display down.

Aggiungi Commento

Remove the battery cover, pressing down on the tabs and sliding.
  • Remove the battery cover, pressing down on the tabs and sliding.

Aggiungi Commento

Unscrew the two (2)  #00, 10 mm screws located below the mic on the back cover.
  • Unscrew the two (2) #00, 10 mm screws located below the mic on the back cover.

Aggiungi Commento

Carefully pry up the top end of the back cover using one finger.
  • Carefully pry up the top end of the back cover using one finger.

Aggiungi Commento

Remove the back plate by using a plastic removal tool to pry the back cover up around the edges.
  • Remove the back plate by using a plastic removal tool to pry the back cover up around the edges.

Aggiungi Commento

Unscrew the circuit board screw.
  • Unscrew the circuit board screw.

  • This screw is located down near the bottom of the device on the blue circuit board. It is just to the right of the USB port.

Aggiungi Commento

Use a plastic removal tool to disconnect the blue  circuit board from the green circuit board underneath.
  • Use a plastic removal tool to disconnect the blue circuit board from the green circuit board underneath.

Aggiungi Commento

Turn the circuit board on its side to reveal the USB soldering points.
  • Turn the circuit board on its side to reveal the USB soldering points.

Aggiungi Commento

De-solder the USB port from its four soldering points.
  • De-solder the USB port from its four soldering points.

  • Be careful not to damage the wire connected to the USB port during de-soldering.

Aggiungi Commento

Place the new USB port in the same spot on the board, and re-solder at each of the four points.
  • Place the new USB port in the same spot on the board, and re-solder at each of the four points.

  • Ensure you re-solder the wire into the same connection you removed it from during desoldering

Aggiungi Commento

Rotate the circuit board back to its initial position, with the port on the underside of the board.
  • Rotate the circuit board back to its initial position, with the port on the underside of the board.

Aggiungi Commento

Replace the circuit board screw.
  • Replace the circuit board screw.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Alex

Membro da: 28/10/2013

731 Reputazione

5 Guide realizzate

the third screw is on the outside of the case, the same place

xhbang - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 4

Ultimi 7 Giorni: 15

Ultimi 30 Giorni: 50

Tutti i Tempi: 2,386