Introduzione

This guide will demonstrate how to replace the back cover of the Balance Board.

Flip device upside-down so the plastic white board is facing the ground.
  • Flip device upside-down so the plastic white board is facing the ground.

  • Locate the four feet in the corners of the Balance Board.

  • Unscrew the three 12.7 mm Philips screws from each foot cover.

Aggiungi Commento

Remove the grey plastic ring from the actual foot by lifting it up.
  • Remove the grey plastic ring from the actual foot by lifting it up.

Aggiungi Commento

Separate the loose foot from the device by lifting it up.
  • Separate the loose foot from the device by lifting it up.

Aggiungi Commento

Repeat steps two and three on the remaining four feet.
  • Repeat steps two and three on the remaining four feet.

Aggiungi Commento

Unscrew the ten 12.7 mm #1 screws.
  • Unscrew the ten 12.7 mm #1 screws.

Aggiungi Commento

Lift off the gray back cover.
  • Lift off the gray back cover.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Cory Olson

Membro da: 29/09/2014

675 Reputazione

4 Guide realizzate

Team

Cal Poly, Team 13-8, Forte Fall 2014 Membro di Cal Poly, Team 13-8, Forte Fall 2014

CPSU-FORTE-F14S13G8

5 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 5

Tutti i Tempi: 280