Introduzione

Hello all, today we will repair a water damaged phone.

it's a simple cell phone and quite easy to repair.

enjoy

Parti

Nessuna parte richiesta.

Remove back cover & battery. Remove back cover & battery. Remove back cover & battery.
  • Remove back cover & battery.

Aggiungi Commento

Remove the front case by prying it open. You will hear clicks. Be careful with taking off screen if you use a spudger.
  • Remove the front case by prying it open. You will hear clicks.

  • Be careful with taking off screen if you use a spudger.

Aggiungi Commento

Use a Torx screwdriver to remove the screen screws. Use a spudger or tweezers to remove the connector of the LCD screen.
  • Use a Torx screwdriver to remove the screen screws.

  • Use a spudger or tweezers to remove the connector of the LCD screen.

Aggiungi Commento

Remove keyboard by prying it open with a spudger. The keyboard is secured with adhesive, be careful! The keyboard is secured with adhesive, be careful!
  • Remove keyboard by prying it open with a spudger.

  • The keyboard is secured with adhesive, be careful!

Aggiungi Commento

The PCB board had water damage, see this in picture 3. To remove the corrosion, dab a cotton swab with a little distilled water on the corroded area, the corrosion will disappear. To remove the corrosion, dab a cotton swab with a little distilled water on the corroded area, the corrosion will disappear.
  • The PCB board had water damage, see this in picture 3.

  • To remove the corrosion, dab a cotton swab with a little distilled water on the corroded area, the corrosion will disappear.

Aggiungi Commento

How and where to use the cotton swabs. How and where to use the cotton swabs.
  • How and where to use the cotton swabs.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 11 persone hanno completato questa guida.

Kevin D

Membro da: 02/05/2014

5.453 Reputazione

24 Guide realizzate

no use .it is not switching on . replaced with good batter also. no on

nabhan75 - Replica

try to clean with an ultrasonic bath.

measure out powerrail.

measure out the voltage coming in on board. try to see if you have short.

Kevin D - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 2

Ultimi 7 Giorni: 30

Ultimi 30 Giorni: 121

Tutti i Tempi: 8,405