Introduzione

Located on the back panel of the burner are four rubber stoppers on each corner. Be sure to have remove to back panel before beginning and be careful to not lose the small nuts and washers holding the screws in place.

Parti

Nessuna parte richiesta.

Remove the screws on the back panel with the #1 Phillips screwdriver bit.
  • Remove the screws on the back panel with the #1 Phillips screwdriver bit.

    • The screws in the rubber legs of the burner do not need to be removed.

    • If the back panel has never been opened before, the screws may be more difficult to unscrew.

Aggiungi Commento

Using a wrench, remove the bolt from the center of the back panel. Using a wrench, remove the bolt from the center of the back panel.
  • Using a wrench, remove the bolt from the center of the back panel.

Aggiungi Commento

The back panel can now be easily lifted off.
  • The back panel can now be easily lifted off.

Aggiungi Commento

While using the wrench to hold the bolt, use the screwdriver to remove the screw. The leg is two separate pieces, the plastic leg and rubber stopper.
  • While using the wrench to hold the bolt, use the screwdriver to remove the screw.

  • The leg is two separate pieces, the plastic leg and rubber stopper.

  • Careful not to lose the bolts and washers as they are very small.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Sun Fai Lau

Membro da: 22/09/2014

513 Reputazione

5 Guide realizzate

Team

USF Tampa, Team 10-7, Brown Fall 2014 Membro di USF Tampa, Team 10-7, Brown Fall 2014

USFT-BROWN-F14S10G7

3 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 89