Introduzione

The TCX905 consists of a two part shell. The back shell is where the battery and back speaker are, the front shell includes the buttons and the screen.

Parti

Nessuna parte richiesta.

Starting from the top of the cover, slide down and away from the phone with your thumb Lift battery cover off of batter and place it to the side
  • Starting from the top of the cover, slide down and away from the phone with your thumb

  • Lift battery cover off of batter and place it to the side

Aggiungi Commento

Once battery cover is removed, place your thumb and index fingers on the the wires near the receptacle Gently pull straight up on the wires until a click is heard which signifies the battery is completely disconnected
  • Once battery cover is removed, place your thumb and index fingers on the the wires near the receptacle

  • Gently pull straight up on the wires until a click is heard which signifies the battery is completely disconnected

  • Place battery pack to the side

Aggiungi Commento

Remove the two 11mm screws inside the battery storage compartment using Phillips #1 screwdriver (located near the very bottom of the phone) Remove the two 11mm screws inside the battery storage compartment using Phillips #1 screwdriver (located near the very bottom of the phone)
  • Remove the two 11mm screws inside the battery storage compartment using Phillips #1 screwdriver (located near the very bottom of the phone)

Aggiungi Commento

Gently open phone casing along the seam at the bottom of the phone using index and middle fingers of both hands Gently open phone casing along the seam at the bottom of the phone using index and middle fingers of both hands Gently open phone casing along the seam at the bottom of the phone using index and middle fingers of both hands
  • Gently open phone casing along the seam at the bottom of the phone using index and middle fingers of both hands

Aggiungi Commento

Ensure that wired connection between circuit board and back shell is not strained Fold the back shell underneath the front shell and circuit board Fold the back shell underneath the front shell and circuit board
  • Ensure that wired connection between circuit board and back shell is not strained

  • Fold the back shell underneath the front shell and circuit board

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Gary Pence

Membro da: 26/03/2014

807 Reputazione

8 Guide realizzate

Team

Clemson, Team 1-1, Benson Spring 2014 Membro di Clemson, Team 1-1, Benson Spring 2014

CLEM-BENSON-S14S1G1

3 Membri

8 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 1

Tutti i Tempi: 222