Aggiusta la tua roba Comunità Store

Trek 820 Tail Light Mounting Bracket Replacement

Cosa ti serve

  1. Trek 820 Tail Light Mounting Bracket Replacement, Tail Light Mounting Bracket: passo 1, immagine 1 di 1

    • Obtain one tail light mounting bracket and one screw as shown in the picture.

    • The screw should be removed from the mounting bracket.

    Traduci

  2. Trek 820 Tail Light Mounting Bracket Replacement: passo 2, immagine 1 di 1

    • Clean the bicycle seat post and mounting bracket.

    • Wrap the mounting bracket strap around the seat post.

    • Verify the larger piece rests towards the tail end aligned with the tires.

    • Verify the bracket's screw hole is on the right side of the bicycle.

    Traduci

  4. Trek 820 Tail Light Mounting Bracket Replacement: passo 3, immagine 1 di 2 Trek 820 Tail Light Mounting Bracket Replacement: passo 3, immagine 2 di 2

    • Locate the slot on the bracket where the strap will be inserted.

    • Insert the strap into the slot.

    • Tighten the strap just enough to keep the bracket in place.

    Traduci

  5. Trek 820 Tail Light Mounting Bracket Replacement: passo 4, immagine 1 di 2 Trek 820 Tail Light Mounting Bracket Replacement: passo 4, immagine 2 di 2

    • Insert the screw into the bracket screw hole.

    • Tighten the screw with fingers until the mounting bracket rests freely on seat post.

    Traduci
Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

con 6 altri collaboratori

Kaveh Karimiyanha

Membro da: 09/24/12

813 Reputazione

7 Guide realizzate

Distintivi: 10

+7 altri distintivi

Team

Cal Poly, Team 1-1, Propen Fall 2012 Membro di Cal Poly, Team 1-1, Propen Fall 2012

CPSU-PROPEN-F12S1G1

5 Membri

9 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 1

Tutti i Tempi: 1,117