Introduzione

This guide will show you how to open your Thrive. Something that must be done for most repairs.

Parti

Nessuna parte richiesta.

Make sure the lock switch for the back cover is unlocked.
  • Make sure the lock switch for the back cover is unlocked.

    • The cover is unlocked when the switch is slid in the direction of the 'unlock' icon.

Aggiungi Commento

Remove back cover by prying away from the Thrive. The easiest place to pry from is one of the two speakers.
  • Remove back cover by prying away from the Thrive.

    • The easiest place to pry from is one of the two speakers.

Aggiungi Commento

To remove the battery, make sure the lock switch is in the unlocked position.
  • To remove the battery, make sure the lock switch is in the unlocked position.

    • The battery is unlocked when the switch is slid to the unlocked position.

Aggiungi Commento

Slide the battery switch release to the right. While holding the switch in place, lift up the battery. While holding the switch in place, lift up the battery.
  • Slide the battery switch release to the right.

    • While holding the switch in place, lift up the battery.

Aggiungi Commento

Start by using a screwdriver to remove the 12 screws holding on the back cover.  The screws are 5mm in length and require a PH0 screwdriver. All of these screws are identical so don't worry about getting them mixed up.
  • Start by using a screwdriver to remove the 12 screws holding on the back cover. The screws are 5mm in length and require a PH0 screwdriver.

    • All of these screws are identical so don't worry about getting them mixed up.

Aggiungi Commento

Start to gently pry the back of the device off, while leaving it loosely in place. Be careful not to tear or damage the cables when removing the back. Be careful not to tear or damage the cables when removing the back.
  • Start to gently pry the back of the device off, while leaving it loosely in place.

    • Be careful not to tear or damage the cables when removing the back.

Aggiungi Commento

Once the back of the case is off, disconnect the wires by gently pulling on the plastic tabs as shown. Once the back of the case is off, disconnect the wires by gently pulling on the plastic tabs as shown. Once the back of the case is off, disconnect the wires by gently pulling on the plastic tabs as shown.
  • Once the back of the case is off, disconnect the wires by gently pulling on the plastic tabs as shown.

Aggiungi Commento

Carefully open the device like a book and lay the two halves beside each other. Carefully open the device like a book and lay the two halves beside each other.
  • Carefully open the device like a book and lay the two halves beside each other.

Can you add a picture of somebody opening the device?

Dan Brown - Replica

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 3 persone hanno completato questa guida.

Kason

Membro da: 22/09/2014

945 Reputazione

5 Guide realizzate

Team

USF Tampa, Team 10-1, Brown Fall 2014 Membro di USF Tampa, Team 10-1, Brown Fall 2014

USFT-BROWN-F14S10G1

3 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 13

Tutti i Tempi: 237