Introduzione

This guide will demonstrate how to dismantle and replace components of your computers display (screen).

Using a bladed tool, gently pry up the display hinge cover. Using a bladed tool, gently pry up the display hinge cover.
  • Using a bladed tool, gently pry up the display hinge cover.

Aggiungi Commento

After folding the display completely back, lift up on the display hinge cover and remove it. After folding the display completely back, lift up on the display hinge cover and remove it.
  • After folding the display completely back, lift up on the display hinge cover and remove it.

Aggiungi Commento

Remove the keyboard. For keyboard removal instructions, see the keyboard guide here: Toshiba Satellite M45 Keyboard Replacement

Aggiungi Commento

Remove the black electrical tape covering the black-and-white antenna cable. There will be 2-3 pieces of tape.
  • Remove the black electrical tape covering the black-and-white antenna cable. There will be 2-3 pieces of tape.

  • After the tape has been removed, close the laptop display, flip the laptop over, and disconnect the black-and-white antenna cables from the WiFi Card.

  • Once the antenna cables are disconnected from the modem card, flip the laptop back over and open the display.

Aggiungi Commento

Remove the two screws securing the display hinges with a #1 size Phillips head screwdriver. It is recommended to keep the screws in a small cup so that you don't lose them. Remove the four screws on the back of the laptop holding the screen in place with a #1 screwdriver. There are two on each side. Remove the four screws on the back of the laptop holding the screen in place with a #1 screwdriver. There are two on each side.
  • Remove the two screws securing the display hinges with a #1 size Phillips head screwdriver. It is recommended to keep the screws in a small cup so that you don't lose them.

  • Remove the four screws on the back of the laptop holding the screen in place with a #1 screwdriver. There are two on each side.

Aggiungi Commento

Remove the display's video connector by gently pulling up.
  • Remove the display's video connector by gently pulling up.

  • Remove the black-and-white antenna cable from the groove.

  • Your display can now be removed.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 3 persone hanno completato questa guida.

Aryn Pauly

Membro da: 29/04/2010

1 Reputazione

2 Guide realizzate

Team

Cal Poly, Team 10-42, Garner Spring 2010 Membro di Cal Poly, Team 10-42, Garner Spring 2010

CPSU-GARNER-S10S10G42

5 Membri

10 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 5

Tutti i Tempi: 7,797