Locate the battery locks on the bottom of the laptop. Slide the right lock outwards, until it locks into place. Slide and hold the left lock outwards and hold it in place.
  • Locate the battery locks on the bottom of the laptop.

  • Slide the right lock outwards, until it locks into place.

  • Slide and hold the left lock outwards and hold it in place.

Aggiungi Commento

While holding the lock in place, slide the battery out towards you.
  • While holding the lock in place, slide the battery out towards you.

Aggiungi Commento

Place device down so the bottom of it is facing you. Unscrew each screw located in the deep holes found around the bottom of the device as shown.
  • Place device down so the bottom of it is facing you.

  • Unscrew each screw located in the deep holes found around the bottom of the device as shown.

always remove the battery before commencing any work on electrical components!

Harley Greaves - Replica

Unscrew the panel located over the RAM as shown Rotate the computer so the battery is now located on the top of the device. Now unscrew the single screw located at the top left of the RAM's housing as shown
  • Unscrew the panel located over the RAM as shown

  • Rotate the computer so the battery is now located on the top of the device. Now unscrew the single screw located at the top left of the RAM's housing as shown

Aggiungi Commento

Remove the battery. Unscrew the single screw closest to the center of the device, as shown in picture two. Remove the four screws that were previously hidden by the battery.
  • Remove the battery.

  • Unscrew the single screw closest to the center of the device, as shown in picture two.

  • Remove the four screws that were previously hidden by the battery.

Aggiungi Commento

Remove the disk drive located at the left of the device. Remove two screws that were hidden by the disk drive, as shown in picture two.
  • Remove the disk drive located at the left of the device.

  • Remove two screws that were hidden by the disk drive, as shown in picture two.

Aggiungi Commento

Now turn the device over so you can see the keyboard. Find the plastic bar located at the top of the keyboard. Pry this plastic cover off with the use of the plastic opening tools.
  • Now turn the device over so you can see the keyboard. Find the plastic bar located at the top of the keyboard.

  • Pry this plastic cover off with the use of the plastic opening tools.

  • Now unscrew the screws that are located under the plastic cover previously removed. After these are gone, remove the keyboard.

Aggiungi Commento

Remove the screws located around the area the keyboard had previously covered, as shown in the red circles. Before removing this cover, locate the connection indicated in the photo and disconnect it. Remove the cover.
  • Remove the screws located around the area the keyboard had previously covered, as shown in the red circles.

  • Before removing this cover, locate the connection indicated in the photo and disconnect it.

  • Remove the cover.

Aggiungi Commento

  • remove all screws on bottom marked F65

Aggiungi Commento

Turn the cover over and remove the back panel.
  • Turn the cover over and remove the back panel.

  • Locate the button found at the lower end of the cover. Once found, remove the four screws keeping it in place.

Aggiungi Commento

Remove the two buses from the button by the blue tab as shown in the pictures. Remove the last bus from the motherboard by pulling the blue tab. Remove the disfunctional button from the device.
  • Remove the two buses from the button by the blue tab as shown in the pictures.

  • Remove the last bus from the motherboard by pulling the blue tab.

  • Remove the disfunctional button from the device.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Alejandro

Membro da: 11/03/2014

109 Reputazione

1 Guida realizzata

Team

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 2

Ultimi 7 Giorni: 11

Ultimi 30 Giorni: 27

Tutti i Tempi: 1,716