Introduzione

This guide will go through the steps needed to install a new LCD panel.

Turn the computer over onto its back.
  • Turn the computer over onto its back.

Aggiungi Commento

Slide the lock on the left side to the unlock position. Slide the lock on the right side to the unlock position until there is a clicking sound.
  • Slide the lock on the left side to the unlock position.

  • Slide the lock on the right side to the unlock position until there is a clicking sound.

Aggiungi Commento

Remove the battery by sliding it out while both locks remain in the unlock position. Remove the battery by sliding it out while both locks remain in the unlock position.
  • Remove the battery by sliding it out while both locks remain in the unlock position.

Aggiungi Commento

Use a plastic opening tool to unsnap the right hand side speaker cover. Use a plastic opening tool to unsnap the right hand side speaker cover.
  • Use a plastic opening tool to unsnap the right hand side speaker cover.

Aggiungi Commento

Remove the rest of the cover by sliding it to the right and lifting the edge. Remove the rest of the cover by sliding it to the right and lifting the edge.
  • Remove the rest of the cover by sliding it to the right and lifting the edge.

Aggiungi Commento

Remove all 8 plastic circular covers on the plastic screen bezel. Only 7 of these plastic covers will contain screws underneath.
  • Remove all 8 plastic circular covers on the plastic screen bezel.

  • Only 7 of these plastic covers will contain screws underneath.

  • Unscrew all screws with a Phillips head #00 screwdriver.

  • Seven 3.5 mm fine thread screws.

Aggiungi Commento

Use a plastic opening tool to separate the screen bezel from the rest of the case. Pull at the top edge of the LCD to separate it from the top part of the case.
  • Use a plastic opening tool to separate the screen bezel from the rest of the case.

  • Pull at the top edge of the LCD to separate it from the top part of the case.

  • Separate the casing and the LCD only by an inch, since there are still wires connecting them.

Aggiungi Commento

Use a Phillips #000 to unscrew the wire connected to the right face of the LCD. One 2.8 mm fine thread screw.
  • Use a Phillips #000 to unscrew the wire connected to the right face of the LCD.

  • One 2.8 mm fine thread screw.

Aggiungi Commento

Flip the LCD over onto the back.
  • Flip the LCD over onto the back.

  • Gently pull the connection on the corner of the LCD to disconnect.

Aggiungi Commento

Remove tape connecting lcd to the inverter. Use tweezers to remove lcd cable from the inverter.
  • Remove tape connecting lcd to the inverter.

  • Use tweezers to remove lcd cable from the inverter.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Alison Wendt

Membro da: 18/04/2013

78 Reputazione

6 Guide realizzate

Team

Cal Poly, Team 21-51, Johann Spring 2013 Membro di Cal Poly, Team 21-51, Johann Spring 2013

CPSU-JOHANN-S13S21G51

3 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 6

Tutti i Tempi: 640