Introduzione

For this guide you will remove the back cover and battery cover in order to replace the battery.

Remove the calculator's protective cover. Place the calculator face down.
  • Remove the calculator's protective cover.

  • Place the calculator face down.

Aggiungi Commento

Using a Phillips #1 screwdriver, remove the six 6mm screws from the back of the case and place them to the side. Start from the notches on the top edge and use your fingers or a prying tool to carefully pry the back cover from the calculator.
  • Using a Phillips #1 screwdriver, remove the six 6mm screws from the back of the case and place them to the side.

  • Start from the notches on the top edge and use your fingers or a prying tool to carefully pry the back cover from the calculator.

Aggiungi Commento

Use a Phillips #00 screwdriver to remove the two 7.5 mm screws holding the battery cover to the case. Remove the battery cover without disconnecting either end of the blue wire.
  • Use a Phillips #00 screwdriver to remove the two 7.5 mm screws holding the battery cover to the case.

  • Remove the battery cover without disconnecting either end of the blue wire.

  • Use your finger to move the battery cover to the side.

Aggiungi Commento

Use the flat side of a spudger to remove the battery by lifting the bottom edge.
  • Use the flat side of a spudger to remove the battery by lifting the bottom edge.

  • When inserting a new battery, check the polarity (+ or -) and insert the new battery with the + side on top.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 3 persone hanno completato questa guida.

Robert Sekerak

Membro da: 25/04/2014

464 Reputazione

4 Guide realizzate

Team

Cal Poly, Team 11-52, Amido Spring 2014 Membro di Cal Poly, Team 11-52, Amido Spring 2014

CPSU-AMIDO-S14S11G52

4 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 10

Ultimi 7 Giorni: 29

Ultimi 30 Giorni: 125

Tutti i Tempi: 4,380