Introduzione

Use this guide to replace a broken or damaged hand strap.

Parti

Nessuna parte richiesta.

Place the lamp LED side down on a clean workspace.
  • Place the lamp LED side down on a clean workspace.

  • Remove the screws holding the casing together using a Phillips #1 Screwdriver.

Aggiungi Commento

Gently pull the two halves of the lamp apart.
  • Gently pull the two halves of the lamp apart.

Aggiungi Commento

Remove both ends of the strap from the orange casing by pulling up.
  • Remove both ends of the strap from the orange casing by pulling up.

Aggiungi Commento

Insert the ends of the new strap into the strap housing on both sides of the orange component.
  • Insert the ends of the new strap into the strap housing on both sides of the orange component.

  • Either strap housing (inner or outer) can be used to adjust the strap length.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Anna

Membro da: 23/10/2014

454 Reputazione

4 Guide realizzate

Team

Michigan Tech, Team 1-3, Lauer Fall 2014 Membro di Michigan Tech, Team 1-3, Lauer Fall 2014

MTU-LAUER-F14S1G3

3 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 68