Unscrew the screws on the top of the radio.
  • Unscrew the screws on the top of the radio.

Aggiungi Commento

Open the CD and cassette doors and remove the screws in the compartments. To open the CD door push on the bottom left corner of the CD door. To open the cassette door push the button that is to the left of the pause button.
  • Open the CD and cassette doors and remove the screws in the compartments.

  • To open the CD door push on the bottom left corner of the CD door. To open the cassette door push the button that is to the left of the pause button.

Aggiungi Commento

Flip the radio upside down and remove the battery cover. Unscrew the one screw below the batteries.
  • Flip the radio upside down and remove the battery cover. Unscrew the one screw below the batteries.

Aggiungi Commento

Remove the top of the radio enough to access the wires for removal.
  • Remove the top of the radio enough to access the wires for removal.

  • Do not forcefully remove the whole top piece of the radio! There will be wires connected to the top cover and circuit board.

Aggiungi Commento

Remove all of the wires that are connected to both the circuit board and the underside of  the top of the radio by pulling them where they are connected
  • Remove all of the wires that are connected to both the circuit board and the underside of the top of the radio by pulling them where they are connected

  • This should include three sets of red and white wires, one set of white wires, one set of black wires, and two ribbon wires. Some cannot be disconnected from the top piece of the radio. Disconnect these plugs from the circuit board.

Aggiungi Commento

On the underside of the cover, unscrew the three screws on the optical pick up unit which is located directly beneath the CD player on the underside of the top face of the radio.
  • On the underside of the cover, unscrew the three screws on the optical pick up unit which is located directly beneath the CD player on the underside of the top face of the radio.

Aggiungi Commento

Insert the new optical pick up unit.
  • Insert the new optical pick up unit.

  • Make sure it is aligned properly.

Aggiungi Commento

Screw in the new optical pick up unit.
  • Screw in the new optical pick up unit.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 10

Ultimi 30 Giorni: 35

Tutti i Tempi: 1,442