Introduzione

This guide shows how to remove the Screens.

Parti

Nessuna parte richiesta.

To remove the back cover, use your thumb to press down on the center of case and slide it off.
  • To remove the back cover, use your thumb to press down on the center of case and slide it off.

Aggiungi Commento

Using a fingernail lift the battery out of the phone.
  • Using a fingernail lift the battery out of the phone.

Aggiungi Commento

To remove the front cover, lift up the case with a fingernail in the small slot as shown.
  • To remove the front cover, lift up the case with a fingernail in the small slot as shown.

Aggiungi Commento

To remove the front grey case, remove the two screws shown with a T5 Torx Screwdriver.
  • To remove the front grey case, remove the two screws shown with a T5 Torx Screwdriver.

Aggiungi Commento

Kit RAM Mac
Accelera il Mac. Porta la memoria al massimo.
Kit RAM Mac
Metti più memoria nel tuo Mac.
Pry up the dark grey case with your fingernail until all four snaps around the top are loose.
  • Pry up the dark grey case with your fingernail until all four snaps around the top are loose.

Aggiungi Commento

Lift up towards the bottom and slide the case off.
  • Lift up towards the bottom and slide the case off.

Aggiungi Commento

Use a plastic opening tool to lift the black tape off of the ribbon cable connector.
  • Use a plastic opening tool to lift the black tape off of the ribbon cable connector.

Aggiungi Commento

Lift the ribbon cable connector lock using a plastic opening tool.
  • Lift the ribbon cable connector lock using a plastic opening tool.

Aggiungi Commento

Slide the black ribbon cable tray out with a plastic opening tool. Shown in the second picture is the try already slid out.
  • Slide the black ribbon cable tray out with a plastic opening tool.

  • Shown in the second picture is the try already slid out.

Aggiungi Commento

Slide the ribbon cable out of the connector. Shown in the second picture is the cable already out.
  • Slide the ribbon cable out of the connector.

  • Shown in the second picture is the cable already out.

Aggiungi Commento

Use a plastic opening tool to lift up on the screen board and release the clips holding it in place.
  • Use a plastic opening tool to lift up on the screen board and release the clips holding it in place.

  • Lift the entire board out of the phone to remove both screens.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Alex Serventi

Membro da: 07/10/2010

50 Reputazione

26 Guide realizzate

Team

Cal Poly, Team 5-15, Maness Fall 2010 Membro di Cal Poly, Team 5-15, Maness Fall 2010

CPSU-MANESS-F10S5G15

4 Membri

26 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 1,093