Introduzione

A guide on how to replace the glass on a Sony Xperia Play.

Remove the 6 silver torx screws marked in red
  • Remove the 6 silver torx screws marked in red

Aggiungi Commento

Remove the 7 black torx screws marked in yellow.
  • Remove the 7 black torx screws marked in yellow.

Aggiungi Commento

Using a plastic prying tool, go around the outside of the phone releasing the plastic clips.
  • Using a plastic prying tool, go around the outside of the phone releasing the plastic clips.

Aggiungi Commento

Remove the plastic housing revealing the motherboard
  • Remove the plastic housing revealing the motherboard

  • Remove the two Phillips screws.

Aggiungi Commento

Remove the headphone jack by carefully moving the dark plastic clip on the connector to 90 degrees
  • Remove the headphone jack by carefully moving the dark plastic clip on the connector to 90 degrees

Aggiungi Commento

Slide the phone to the open position
  • Slide the phone to the open position

Aggiungi Commento

Remove the display connector  marked in orange using a plastic spudger to pry it upwards
  • Remove the display connector marked in orange using a plastic spudger to pry it upwards

  • Remove the connector for the front buttons by prising the retaining clip to 90 degrees

Aggiungi Commento

Remove motherboard
  • Remove motherboard

Aggiungi Commento

Remove the buttons from the phone
  • Remove the buttons from the phone

Aggiungi Commento

Remove the three Phillips screws.
  • Remove the three Phillips screws.

Aggiungi Commento

Slide the metal frame across revealing the last screw . Make sure to keep the plastic cover after removing the screw
  • Slide the metal frame across revealing the last screw . Make sure to keep the plastic cover after removing the screw

  • Disconnect the digitizer cable

Aggiungi Commento

Insert a plastic spudger around the edge of the frame and take the lcd assembely from the glass
  • Insert a plastic spudger around the edge of the frame and take the lcd assembely from the glass

  • Using a heat gun heat around the edges of the glass to soften the glue, and use your prying tool between the glass and the frame to take the glass off.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 15 persone hanno completato questa guida.

Kris James

Membro da: 27/01/2012

567 Reputazione

1 Guida realizzata

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 10

Ultimi 30 Giorni: 35

Tutti i Tempi: 29,821