Introduzione

This guide provides instruction for installing a motherboard for the Sony Ericsson TM506 cell phone.

Parti

Nessuna parte richiesta.

Firmly hold the phone between your fingers with your thumb on the battery cover. Push down with your thumb until the battery cover comes off. Push down with your thumb until the battery cover comes off.
  • Firmly hold the phone between your fingers with your thumb on the battery cover.

  • Push down with your thumb until the battery cover comes off.

Aggiungi Commento

Unscrew the bottom two 5.4mm screws with a Torx T6 screwdriver. Unscrew the bottom two 5.4mm screws with a Torx T6 screwdriver. Unscrew the bottom two 5.4mm screws with a Torx T6 screwdriver.
  • Unscrew the bottom two 5.4mm screws with a Torx T6 screwdriver.

Aggiungi Commento

Remove the two rubber casings for the top two screws with a plastic opening tool. Remove the two rubber casings for the top two screws with a plastic opening tool.
  • Remove the two rubber casings for the top two screws with a plastic opening tool.

Aggiungi Commento

Unscrew these two 5.4mm screws with a Torx T6 screwdriver.
  • Unscrew these two 5.4mm screws with a Torx T6 screwdriver.

Aggiungi Commento

There are eight snap hooks located around the outer case. Carefully snap these to remove the outer case. There are eight snap hooks located around the outer case. Carefully snap these to remove the outer case. There are eight snap hooks located around the outer case. Carefully snap these to remove the outer case.
  • There are eight snap hooks located around the outer case. Carefully snap these to remove the outer case.

Aggiungi Commento

The sound box is attached to the case by two snap hooks. Lift the sound box up to remove it from the case. Lift the sound box up to remove it from the case.
  • The sound box is attached to the case by two snap hooks.

  • Lift the sound box up to remove it from the case.

Aggiungi Commento

Locate the 80-pin connector. Carefully, lift up on the connector to separate it from the board.
  • Locate the 80-pin connector.

  • Carefully, lift up on the connector to separate it from the board.

Aggiungi Commento

There are two snap hooks that attach the motherboard to the case. Using a plastic opening tool, carefully lift up on the motherboard to detach it. The motherboard is extremely fragile. Try to be forceful yet delicate in the removal because it will not come off easily.
  • There are two snap hooks that attach the motherboard to the case.

  • Using a plastic opening tool, carefully lift up on the motherboard to detach it.

  • The motherboard is extremely fragile. Try to be forceful yet delicate in the removal because it will not come off easily.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Daniel

Membro da: 20/06/2012

71 Reputazione

14 Guide realizzate

Team

Cal Poly, Team 1-1, Regan SU 2012 Membro di Cal Poly, Team 1-1, Regan SU 2012

CPSU-REGAN-SU12S1G1

2 Membri

16 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 981