Introduzione

This guide will assist you in removing the microphone from your Sony Ericsson T68i.

Parti

Nessuna parte richiesta.

Remove the battery from the back. Remove the battery from the back.
  • Remove the battery from the back.

Aggiungi Commento

Pry off the plastic cover from the top with a thin plastic shim, then remove it from the two bottom clips. Do not bend it too far down, or else you risk breaking the two bottom clips. Do not bend it too far down, or else you risk breaking the two bottom clips.
  • Pry off the plastic cover from the top with a thin plastic shim, then remove it from the two bottom clips.

  • Do not bend it too far down, or else you risk breaking the two bottom clips.

Aggiungi Commento

Unscrew all four Torx T6 screws. Keep in a safe place. Keep in a safe place.
  • Unscrew all four Torx T6 screws.

  • Keep in a safe place.

Aggiungi Commento

After removing the screws, the two halves will separate. If not, then pry them gently apart. After removing the screws, the two halves will separate. If not, then pry them gently apart. After removing the screws, the two halves will separate. If not, then pry them gently apart.
  • After removing the screws, the two halves will separate. If not, then pry them gently apart.

Aggiungi Commento

Next remove the circuit board and screen from the device. Use your T6 to remove the 4 screws holding the cover on. Use your T6 to remove the 4 screws holding the cover on.
  • Next remove the circuit board and screen from the device.

  • Use your T6 to remove the 4 screws holding the cover on.

Aggiungi Commento

The board and screen should just pop out at this point. The board and screen should just pop out at this point. The board and screen should just pop out at this point.
  • The board and screen should just pop out at this point.

Aggiungi Commento

The microphone at the bottom of the rear housing can be levered out using a small screwdriver or any similar tool. The microphone at the bottom of the rear housing can be levered out using a small screwdriver or any similar tool.
  • The microphone at the bottom of the rear housing can be levered out using a small screwdriver or any similar tool.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Tim Dascomb

Membro da: 13/04/2010

123 Reputazione

13 Guide realizzate

Team

Cal Poly, Team 26-34, Regan Spring 2010 Membro di Cal Poly, Team 26-34, Regan Spring 2010

CPSU-REGAN-S10S26G34

4 Membri

13 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 2

Tutti i Tempi: 2,009