Introduzione

The flash bulb is the component of the camera responsible for illuminating the surroundings of the images. Replacing the flash bulb will require the removal of battery and black plastic housing that holds the CCD chip.

Parti

Nessuna parte richiesta.

Locate the cover on the bottom of the camera.
  • Locate the cover on the bottom of the camera.

  • Slide the cover towards the back of the camera.

  • Be careful—the battery can slide out on its own.

Aggiungi Commento

Carefully remove the exposed battery.
  • Carefully remove the exposed battery.

    • If it is difficult to remove, flip over the camera and the battery will slide out.

Aggiungi Commento

Locate and remove the 3mm screws on the top and sides of the camera with the size 00 screwdriver. Locate and remove the 3mm screws on the top and sides of the camera with the size 00 screwdriver. Locate and remove the 3mm screws on the top and sides of the camera with the size 00 screwdriver.
  • Locate and remove the 3mm screws on the top and sides of the camera with the size 00 screwdriver.

Aggiungi Commento

Pull the two halves of the camera apart.
  • Pull the two halves of the camera apart.

  • Place the two halves down with the insides facing you.

Aggiungi Commento

Find the two clips holding the motherboard to the black lens box.
  • Find the two clips holding the motherboard to the black lens box.

  • Slide the plastic opening tool in between the ribbon and the black part of the clip, then flip it. (If difficult, your fingernail can also be used)

Aggiungi Commento

After releasing the clips, pull out black lens box.
  • After releasing the clips, pull out black lens box.

Aggiungi Commento

Use the plastic opening tool to flip the clip. Use the plastic opening tool to flip the clip.
  • Use the plastic opening tool to flip the clip.

Aggiungi Commento

Grab the white part and slide it to the right until it clicks. This may require some force.
  • Grab the white part and slide it to the right until it clicks.

    • This may require some force.

  • Pull out the flash.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Paul Elrich

Membro da: 12/04/2012

15 Reputazione

2 Guide realizzate

Team

Cal Poly, Team 7-35, Maness Spring 2012 Membro di Cal Poly, Team 7-35, Maness Spring 2012

CPSU-MANESS-S12S7G35

4 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 5

Tutti i Tempi: 515