Introduzione

This guide explains how to replace the viewfinder in the Sony Cybershot DSC-P52

Open the battery compartment and remove the batteries.
  • Open the battery compartment and remove the batteries.

  • Remove all of the visible screws on the outside of the case.

  • There should be three of them that are all easily located.

Aggiungi Commento

Open the memory card compartment.
  • Open the memory card compartment.

  • Remove the screw next to the memory card slot.

Aggiungi Commento

Pull apart the front and back cover pieces carefully.
  • Pull apart the front and back cover pieces carefully.

  • The front cover should come completely free with little effort.

  • The back cover will still be attached to the circuit board.

Aggiungi Commento

Simultaneously unclip all of the clips holding in the circuitry. Remove the back case.
  • Simultaneously unclip all of the clips holding in the circuitry. Remove the back case.

  • The circuitry will still be connected to the back case by ribbon cables.

Aggiungi Commento

Open the case as shown.
  • Open the case as shown.

Aggiungi Commento

Unclip the clip holding the ribbon cable in.
  • Unclip the clip holding the ribbon cable in.

  • Other ribbon cables might not have a clips.

Aggiungi Commento

Pull the ribbon cable out.
  • Pull the ribbon cable out.

Aggiungi Commento

Remove the two additional screws on the back of the lens.
  • Remove the two additional screws on the back of the lens.

Aggiungi Commento

Detach the ribbon cables and unplug the cable leading to the back of the motherboard.
  • Detach the ribbon cables and unplug the cable leading to the back of the motherboard.

Aggiungi Commento

Remove the motherboard and the flash from the rest of the hardware.
  • Remove the motherboard and the flash from the rest of the hardware.

Aggiungi Commento

Remove the screw indicated in the picture to detach the lens and the  viewfinder from the other hardware.
  • Remove the screw indicated in the picture to detach the lens and the viewfinder from the other hardware.

Aggiungi Commento

Remove the three screws shown to separate the lens from the viewfinder.
  • Remove the three screws shown to separate the lens from the viewfinder.

Aggiungi Commento

Purchase a new viewfinder.
  • Purchase a new viewfinder.

  • Repeat the previous steps in reverse order to rebuild.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Kari Johnson

Membro da: 10/01/2011

127 Reputazione

2 Guide realizzate

Team

Cal Poly, Team 3-43, Regan Winter 2011 Membro di Cal Poly, Team 3-43, Regan Winter 2011

CPSU-REGAN-W11S3G43

4 Membri

10 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 1

Tutti i Tempi: 2,000