Introduzione

This guide explains how to remove and replace the shutter motor in the Sony Cybershot DSC-P52

Open the battery compartment and remove the batteries.
  • Open the battery compartment and remove the batteries.

  • Remove all of the visible screws on the outside of the case.

  • There should be three of them that are all easily located.

Aggiungi Commento

Open the memory card compartment.
  • Open the memory card compartment.

  • Remove the screw next to the memory card slot.

Aggiungi Commento

Pull apart the front and back cover pieces carefully.
  • Pull apart the front and back cover pieces carefully.

  • The front cover should come completely free with little effort.

  • The back cover will still be attached to the circuit board.

Aggiungi Commento

Simultaneously unclip all of the clips holding in the circuitry. Remove the back case.
  • Simultaneously unclip all of the clips holding in the circuitry. Remove the back case.

  • The circuitry will still be connected to the back case by ribbon cables.

Aggiungi Commento

Kit RAM Mac
Accelera il Mac. Porta la memoria al massimo.
Kit RAM Mac
Metti più memoria nel tuo Mac.
Open the case as shown.
  • Open the case as shown.

Aggiungi Commento

Unclip the clip holding the ribbon cable in.
  • Unclip the clip holding the ribbon cable in.

  • Other ribbon cables might not have a clips.

Aggiungi Commento

Pull the ribbon cable out.
  • Pull the ribbon cable out.

Aggiungi Commento

Remove all six screws on the front side of the motherboard circled in the picture.
  • Remove all six screws on the front side of the motherboard circled in the picture.

  • Pull the motherboard from the rest of the housing.

  • It will still be connected to the flash unit.

Aggiungi Commento

Remove the cable on the back side of the motherboard.
  • Remove the cable on the back side of the motherboard.

Aggiungi Commento

Detach the ribbon cables shown.
  • Detach the ribbon cables shown.

  • Careful! Touching the leads of the large yellow capacitor can result in a painful shock.

  • Remove the flash unit from the motherboard.

Aggiungi Commento

Remove screw securing motor and mount in place.
  • Remove screw securing motor and mount in place.

  • Be careful to leave shutter gears in the correct position

Aggiungi Commento

Remove the two screws holding motor to mount/gears.
  • Remove the two screws holding motor to mount/gears.

  • Remove the motor from the mount.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Greg Hermansen

Membro da: 28/01/2011

25 Reputazione

1 Guida realizzata

Team

Cal Poly, Team 3-43, Regan Winter 2011 Membro di Cal Poly, Team 3-43, Regan Winter 2011

CPSU-REGAN-W11S3G43

4 Membri

10 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 3

Tutti i Tempi: 4,448