Parti

Nessuna parte richiesta.

Remove 2 screws from thumb dial panel on the back of the device.
  • Remove 2 screws from thumb dial panel on the back of the device.

Aggiungi Commento

Remove 1 screw from upper right corner on the back of the device.
  • Remove 1 screw from upper right corner on the back of the device.

Aggiungi Commento

Remove 1 screw from thumb dial panel on the right side of the device.
  • Remove 1 screw from thumb dial panel on the right side of the device.

Aggiungi Commento

Remove screw from lower right side of the device.
  • Remove screw from lower right side of the device.

Aggiungi Commento

Remove 1 screw from the lower left side of the device.
  • Remove 1 screw from the lower left side of the device.

Aggiungi Commento

Remove 2 screws from the bottom of the device.
  • Remove 2 screws from the bottom of the device.

Aggiungi Commento

Remove the thumb dial panel by sliding it away from the device.
  • Remove the thumb dial panel by sliding it away from the device.

Aggiungi Commento

Remove the back panel exposing the inside of the device.
  • Remove the back panel exposing the inside of the device.

Aggiungi Commento

Locate thumb dial on top right side of the board.
  • Locate thumb dial on top right side of the board.

Aggiungi Commento

Follow ribbon wire to locate where it plugs into the board.  The plug is a flat black square.
  • Follow ribbon wire to locate where it plugs into the board. The plug is a flat black square.

Aggiungi Commento

Pull plug straight up to remove from board.
  • Pull plug straight up to remove from board.

Aggiungi Commento

Place plug back on board and push down on center to secure to board.
  • Place plug back on board and push down on center to secure to board.

Aggiungi Commento

Make sure new thumb dial is sitting flat and the screw holes line up with holes in the board.
  • Make sure new thumb dial is sitting flat and the screw holes line up with holes in the board.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Rob

Membro da: 04/10/2011

1 Reputazione

2 Guide realizzate

Team

UW Stout, Team 5-6, Zhou Fall 2011 Membro di UW Stout, Team 5-6, Zhou Fall 2011

UWSTOUT-ZHOU-F11S5G6

4 Membri

2 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 2

Tutti i Tempi: 864