Parti

Nessuna parte richiesta.

Remove two screws from the thumb dial panel on the back of the device
  • Remove two screws from the thumb dial panel on the back of the device

Aggiungi Commento

Remove 1 screw from upper right corner on the back of the device.
  • Remove 1 screw from upper right corner on the back of the device.

Aggiungi Commento

Romove 1 screw from thumb dial panel on the righ side of the device.
  • Romove 1 screw from thumb dial panel on the righ side of the device.

Aggiungi Commento

Remove screw from lower right side of the device.
  • Remove screw from lower right side of the device.

Aggiungi Commento

Remove 1 screw from the lower left side of the device.
  • Remove 1 screw from the lower left side of the device.

Aggiungi Commento

Romove 2 screws from the bottom of the device.
  • Romove 2 screws from the bottom of the device.

Aggiungi Commento

Remove the thumb dial panel by sliding it away from the device.  (note: you can do this step earlier after you remove all screws from thumb drive panel)
  • Remove the thumb dial panel by sliding it away from the device. (note: you can do this step earlier after you remove all screws from thumb drive panel)

Aggiungi Commento

Remove the back panel exposing the inside of the device.
  • Remove the back panel exposing the inside of the device.

Aggiungi Commento

Remove 1 screw located on board below battery.
  • Remove 1 screw located on board below battery.

Aggiungi Commento

Unplug male battery plug on the battery wire from the female battery plug on the board.
  • Unplug male battery plug on the battery wire from the female battery plug on the board.

Aggiungi Commento

remove the battery from the device by sliding it out of the side of the device
  • remove the battery from the device by sliding it out of the side of the device

Aggiungi Commento

slide new battery under the board from the side of the device.
  • slide new battery under the board from the side of the device.

Aggiungi Commento

Plug battery back into board.
  • Plug battery back into board.

Aggiungi Commento

Place screw back into board.
  • Place screw back into board.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Rob

Membro da: 04/10/2011

1 Reputazione

2 Guide realizzate

Team

UW Stout, Team 5-6, Zhou Fall 2011 Membro di UW Stout, Team 5-6, Zhou Fall 2011

UWSTOUT-ZHOU-F11S5G6

4 Membri

2 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 7

Tutti i Tempi: 1,437