Introduzione

If the screen is damaged, then you may need to replace it. This guide will walk you through the process of replacing your screen with a new one.

Remove the two 1.5mm screws (one on the right and one on the left side)  on the screen portion of the device with a Phillips #00 screwdriver.
  • Remove the two 1.5mm screws (one on the right and one on the left side) on the screen portion of the device with a Phillips #00 screwdriver.

Aggiungi Commento

Remove the two 1.5mm screws on the bottom of the screen module with a Phillips #00 screwdriver.
  • Remove the two 1.5mm screws on the bottom of the screen module with a Phillips #00 screwdriver.

Aggiungi Commento

Remove the plastic wrapping on the side of the top portion of the device. This is done by first sliding the wrapping up to disengage the plastic hooks, then peeling the plastic away starting from either end.
  • Remove the plastic wrapping on the side of the top portion of the device. This is done by first sliding the wrapping up to disengage the plastic hooks, then peeling the plastic away starting from either end.

Aggiungi Commento

Remove four 2.0mm screws on the side of the screen portion of the device with a Phillips #00 screwdriver.
  • Remove four 2.0mm screws on the side of the screen portion of the device with a Phillips #00 screwdriver.

Aggiungi Commento

Remove top .75mm screw of the top portion of device with a Phillips #00 screwdriver.
  • Remove top .75mm screw of the top portion of device with a Phillips #00 screwdriver.

Aggiungi Commento

Remove front panel from the screen. You should be able to do this by gently pulling the pieces apart with your hands
  • Remove front panel from the screen. You should be able to do this by gently pulling the pieces apart with your hands

Aggiungi Commento

Pry the screen from the back panel using the plastic opening tools to remove the screen module.
  • Pry the screen from the back panel using the plastic opening tools to remove the screen module.

Aggiungi Commento

Remove the tape from the wires on the back side of the screen module.
  • Remove the tape from the wires on the back side of the screen module.

Aggiungi Commento

Disconnect the screen from the device by gently pulling the two display data cables away from the bottom of the screen module with your fingers.
  • Disconnect the screen from the device by gently pulling the two display data cables away from the bottom of the screen module with your fingers.

  • Be careful not to damage the display data cables! They are thin.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Courtney

Membro da: 19/04/2013

13 Reputazione

2 Guide realizzate

Team

Cal Poly, Team 14-11, Maness Spring 2013 Membro di Cal Poly, Team 14-11, Maness Spring 2013

CPSU-MANESS-S13S14G11

5 Membri

8 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 5

Tutti i Tempi: 484