Introduzione

This guide will show how to remove and replace the face-plate eject lever on the device.

Before any repair work can be done one must remove the device for the vehicle. To do so follow this link to see a general vehicle removal of a stereo system.

Parti

Nessuna parte richiesta.

Locate face-plate eject button.
  • Locate face-plate eject button.

Aggiungi Commento

Press the eject button. Remove the face-plate.
  • Press the eject button.

  • Remove the face-plate.

Aggiungi Commento

Remove two 4.9mm Phillips #00screws on the front of the device. Remove two 7.5mm Phillips #00screws on the front of the device. When the screws are removed, the eject lever may fall into the device. Make sure the device is held horizontal and level.
  • Remove two 4.9mm Phillips #00screws on the front of the device.

  • Remove two 7.5mm Phillips #00screws on the front of the device.

  • When the screws are removed, the eject lever may fall into the device. Make sure the device is held horizontal and level.

The screws in red do not seem to need to be removed unless you are trying to replace the eject lever. If you're not trying to replace the lever, it adds an unnecessary complication to putting it back together.

Dale Pearson - Replica

Rotate device 90 degrees to either side. Use the plastic opening tool to pry open the top and bottom tab respectively.
  • Rotate device 90 degrees to either side.

  • Use the plastic opening tool to pry open the top and bottom tab respectively.

  • Repeat on opposite side.

Aggiungi Commento

Remove front panel.
  • Remove front panel.

Aggiungi Commento

Remove the eject lever.
  • Remove the eject lever.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Team

USF Tampa, Team 10-2, Brown Fall 2014 Membro di USF Tampa, Team 10-2, Brown Fall 2014

USFT-BROWN-F14S10G2

3 Membri

7 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 17

Tutti i Tempi: 1,087