Salta al contenuto principale

Sony Bloggie 3D Player USB Drive Replacement

Cosa ti serve

  1. Sony Bloggie 3D Player USB Drive Replacement, Front Cover: passo 1, immagine 1 di 1
    • Remove the two 2.5mm Phillips #00 screws using the Philips #00 screwdriver.

  2. Sony Bloggie 3D Player USB Drive Replacement: passo 2, immagine 1 di 2 Sony Bloggie 3D Player USB Drive Replacement: passo 2, immagine 2 di 2
    • Use a plastic opening tool to pry the cover open.

    • After the the cover is partly open as shown, remove the cover with your hands.

  3. Sony Bloggie 3D Player USB Drive Replacement, Back Cover: passo 3, immagine 1 di 2 Sony Bloggie 3D Player USB Drive Replacement, Back Cover: passo 3, immagine 2 di 2
    • Using your hand, or a pair of tweezers, remove the ZIF connector by gently pulling it out of the dock on the circuit board.

  4. Sony Bloggie 3D Player USB Drive Replacement: passo 4, immagine 1 di 2 Sony Bloggie 3D Player USB Drive Replacement: passo 4, immagine 2 di 2
    • Use a plastic opening tool to loosen the back cover off the device.

    • Once the back cover is loose, remove it gently by hand.

  5. Sony Bloggie 3D Player USB Drive Replacement, USB Drive: passo 5, immagine 1 di 2 Sony Bloggie 3D Player USB Drive Replacement, USB Drive: passo 5, immagine 2 di 2
    • Once the back cover is removed, by using the opening tool, remove the following screws using a Phillips #00 screwdriver.

    • Two 4.0mm Phillips #00 screws

    • One 8.0mm Phillips #00 screw

    • One 9.5mm Phillips #00 screw

  6. Sony Bloggie 3D Player USB Drive Replacement: passo 6, immagine 1 di 2 Sony Bloggie 3D Player USB Drive Replacement: passo 6, immagine 2 di 2
    • Using a spudger, remove the clips of the metal casing from each end of the USB drive.

  7. Sony Bloggie 3D Player USB Drive Replacement: passo 7, immagine 1 di 2 Sony Bloggie 3D Player USB Drive Replacement: passo 7, immagine 2 di 2
    • Carefully lift the USB drive off of the peg that it is attached to.

  8. Sony Bloggie 3D Player USB Drive Replacement: passo 8, immagine 1 di 1
    • Now that the USB component is on its own, untangle the ribbon from inside the device.

  9. Sony Bloggie 3D Player USB Drive Replacement: passo 9, immagine 1 di 1
    • Now remove the ZIF connector from the device using a pair of tweezers.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Craig Sweet

Membro da: 01/11/13

1 Reputazione

1 Guida realizzata

Team

Cal Poly, Team 7-12, Maness Winter 2013 Membro di Cal Poly, Team 7-12, Maness Winter 2013

CPSU-MANESS-W13S7G12

5 Membri

12 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 3

Tutti i Tempi: 486