Introduzione

This is a guide to replace your Skullcandy Air Raid's Speakers.

Starting with the corners, gently pull the rubber cover off of the device.
  • Starting with the corners, gently pull the rubber cover off of the device.

Aggiungi Commento

Using the T-6 hexagonal screwdriver, unscrew the four 10mm #6 hex screws on the right side of the device.
  • Using the T-6 hexagonal screwdriver, unscrew the four 10mm #6 hex screws on the right side of the device.

  • Remove the handle from the device.

Aggiungi Commento

Unscrew the two screws on the left side of the device using the phillips #00 screwdriver.
  • Unscrew the two screws on the left side of the device using the phillips #00 screwdriver.

    • One 5mm Phillips screw.

    • One 8mm Phillips screw.

Aggiungi Commento

Gently pull the sides of the front plate outwards from the device.
  • Gently pull the sides of the front plate outwards from the device.

  • Pull up on the front plate to remove it from the device.

Aggiungi Commento

Using a #000 Phillips Screwdriver, unscrew the four 0.8 cm Philips screws from each corner of the speaker you are replacing (eight 0.8 Philips screws total).
  • Using a #000 Phillips Screwdriver, unscrew the four 0.8 cm Philips screws from each corner of the speaker you are replacing (eight 0.8 Philips screws total).

Aggiungi Commento

Using the plastic opening tool, pry around edges of speaker to loosen glue contact with front plate.
  • Using the plastic opening tool, pry around edges of speaker to loosen glue contact with front plate.

  • If you are unable to loosen glue contact using the plastic opening tool, use a heat gun to assist in removal.

Aggiungi Commento

Lift the speaker out of the device.
  • Lift the speaker out of the device.

  • Be aware of the connection with the ribbon cable.

  • For reassembly, ensure proper orientation of the cable plug.

Aggiungi Commento

Firmly pull on the end of the ribbon cable to disconnect the speaker from the motherboard.
  • Firmly pull on the end of the ribbon cable to disconnect the speaker from the motherboard.

Aggiungi Commento

Desolder the black and red wires from the speaker.
  • Desolder the black and red wires from the speaker.

  • The red wire is for the left speaker and the black is for the right speaker.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Where can I buy the replacement speaker?

Luis Polino - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 2

Ultimi 7 Giorni: 5

Ultimi 30 Giorni: 17

Tutti i Tempi: 897