Salta al contenuto principale

Sega Dreamcast Power Supply Replacement

Cosa ti serve

  1. Sega Dreamcast Power Supply Replacement, Expansion Bay: passo 1, immagine 1 di 2 Sega Dreamcast Power Supply Replacement, Expansion Bay: passo 1, immagine 2 di 2
    • Verify that the console is disconnected from the AC outlet before you begin.

    • Flip the console over on its back.

    • Take note of your model number, in case replacement parts are needed.

  2. Sega Dreamcast Power Supply Replacement: passo 2, immagine 1 di 3 Sega Dreamcast Power Supply Replacement: passo 2, immagine 2 di 3 Sega Dreamcast Power Supply Replacement: passo 2, immagine 3 di 3
    • Remove the expansion bay by applying pressure to the small clip on the expansion bay while prying it away from the console.

  3. Sega Dreamcast Power Supply Replacement, Top Cover: passo 3, immagine 1 di 1
    • Locate and remove all four black 12mm Phillips #02 screws from the underside of the console.

    • Note: Remove the expansion bay to locate the fourth screw

  4. Sega Dreamcast Power Supply Replacement: passo 4, immagine 1 di 1
    • Internal components can be loose. Be careful that they do not fall out when removing the cover.

    • Turn the console right side up.

    • Remove the top cover by gently lifting the upper portion of the console.

  5. Sega Dreamcast Power Supply Replacement, Power Supply: passo 5, immagine 1 di 2 Sega Dreamcast Power Supply Replacement, Power Supply: passo 5, immagine 2 di 2
    • Unplug the device from the outlet. If you have just powered off the system, allow a few minutes for the capacitors to discharge before you begin working.

    • Remove the white female pin head by pinching and lifting directly up on the harness.

    • Remove the two Philips #02 screws from the board.

    • Remove the power board. Using both hands, gently lift the power board away from the console without damaging the male pin head

  6. Sega Dreamcast Power Supply Replacement: passo 6, immagine 1 di 2 Sega Dreamcast Power Supply Replacement: passo 6, immagine 2 di 2
    • Remove the unit. Carefully remove the power board from the console by lightly grasping the board by the edge and lifting directly upward.

    • Remove the two 10mm #02 Philips screws to detach the switch module from the console.

    • Purchase a replacement power board.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 6 persone hanno completato questa guida.

Jacks216

Membro da: 11/25/09

99 Reputazione

1 Guida realizzata

Team

Cal Poly, Team 5-1, Regan Fall 2009 Membro di Cal Poly, Team 5-1, Regan Fall 2009

CPSU-REGAN-F09S5G1

5 Membri

21 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 9

Ultimi 30 Giorni: 71

Tutti i Tempi: 17,104