Parti

Nessuna parte richiesta.

Using a Phillips head screwdriver remove  six screws from the bottom of the console. The six screws are marked.
  • Using a Phillips head screwdriver remove six screws from the bottom of the console.

    • The six screws are marked.

Aggiungi Commento

Remove the two screws that attach the Genesis' connector to the rest of the console.
  • Remove the two screws that attach the Genesis' connector to the rest of the console.

    • The two screws are marked in the diagram.

Aggiungi Commento

Slide the lock tab to the left to separate the halves of the console.
  • Slide the lock tab to the left to separate the halves of the console.

Aggiungi Commento

Lift from the left side to remove the top of the case.
  • Lift from the left side to remove the top of the case.

Aggiungi Commento

Using the spudger, pry the cover off of the Genesis attachment.
  • Using the spudger, pry the cover off of the Genesis attachment.

Aggiungi Commento

Lift the top of the case to remove the cover.
  • Lift the top of the case to remove the cover.

Aggiungi Commento

Remove the faceplate by pulling it up, then out.
  • Remove the faceplate by pulling it up, then out.

Aggiungi Commento

Remove metal plate by unscrewing the three screws with the Phillips head screwdriver and then lifting the plate. The three screws are shown on the diagram.
  • Remove metal plate by unscrewing the three screws with the Phillips head screwdriver and then lifting the plate.

    • The three screws are shown on the diagram.

Aggiungi Commento

Remove the two screws from the plastic bar. The two screws are shown pictured.
  • Remove the two screws from the plastic bar.

    • The two screws are shown pictured.

Aggiungi Commento

To remove the CD tray Remove the four screws with the Phillips head screwdriver.
  • To remove the CD tray

    • Remove the four screws with the Phillips head screwdriver.

Aggiungi Commento

Carefully unplug the wire connected to optical reader.
  • Carefully unplug the wire connected to optical reader.

Aggiungi Commento

Remove the four screws on the underside of the CD tray with a small Phillips head screwdriver. The four screws are highlighted on the diagram.
  • Remove the four screws on the underside of the CD tray with a small Phillips head screwdriver.

    • The four screws are highlighted on the diagram.

  • The four springs below the circuit board are attached to the screws, so be careful not to lose them when you remove the screws.

Aggiungi Commento

Carefully remove the CD tray from circuit board.
  • Carefully remove the CD tray from circuit board.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

sskyllin

Membro da: 18/10/2010

21 Reputazione

2 Guide realizzate

Team

Cal Poly, Team 5-14, Maness Fall 2010 Membro di Cal Poly, Team 5-14, Maness Fall 2010

CPSU-MANESS-F10S5G14

5 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 24

Tutti i Tempi: 6,676