Salta al contenuto principale

Sceptre X9 Komodo VII Speakers Replacement

Cosa ti serve

  1. Sceptre X9 Komodo VII Speakers Replacement, Stand: passo 1, immagine 1 di 1
    • Place the monitor face down.

    • Remove the four 11.5mm screws with a #2 Phillips screwdriver.

    • Remove the stand by pulling it out.

  2. Sceptre X9 Komodo VII Speakers Replacement: passo 2, immagine 1 di 1
    • Remove two 11.5mm screws with a #2 Phillips screwdriver.

    • Remove the plastic bar.

  3. Sceptre X9 Komodo VII Speakers Replacement, Board Cover: passo 3, immagine 1 di 1
    • Using a #2 Phillips screwdriver, remove the six 7mm screws at the circled locations.

  4. Sceptre X9 Komodo VII Speakers Replacement: passo 4, immagine 1 di 3 Sceptre X9 Komodo VII Speakers Replacement: passo 4, immagine 2 di 3 Sceptre X9 Komodo VII Speakers Replacement: passo 4, immagine 3 di 3
    • Pry the monitor using the plastic opening tool to release the clips holding the cover on.

    • There are four clips on each side, four on the top, and one on the bottom.

    • You may hear a loud snapping noise when releasing the clips. Do not be alarmed, it is natural.

    • Once all the clips have been released, remove the cover by pulling it up.

  5. Sceptre X9 Komodo VII Speakers Replacement: passo 5, immagine 1 di 2 Sceptre X9 Komodo VII Speakers Replacement: passo 5, immagine 2 di 2
    • Using the #2 Phillips screwdriver, remove the one 6mm screw.

    • Unplug the indicated cable by pulling on the base.

    • Slide the cover toward the top of the monitor.

    • Remove the cover.

  6. Sceptre X9 Komodo VII Speakers Replacement, Speakers: passo 6, immagine 1 di 1
    • Disconnect the two connectors to the speakers by gently pulling on the hard plastic straight up.

  7. Sceptre X9 Komodo VII Speakers Replacement: passo 7, immagine 1 di 1
    • Carefully peel the tape from the board.

  8. Sceptre X9 Komodo VII Speakers Replacement: passo 8, immagine 1 di 1
    • Flip the monitor so the screen is facing you.

    • Using Phillips #2 screwdriver remove the four 6.25 mm screws securing the speakers:

  9. Sceptre X9 Komodo VII Speakers Replacement: passo 9, immagine 1 di 1
    • Carefully lift the speakers up.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Team

Cal Poly, Team 16-56, Forte Fall 2012 Membro di Cal Poly, Team 16-56, Forte Fall 2012

CPSU-FORTE-F12S16G56

5 Membri

13 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 2

Tutti i Tempi: 394