Introduzione

The motherboard is the core component of the device, and removing it will not be an easy task. The keypad is attached to the motherboard and will remain attached at the end of this guide.

Parti

Nessuna parte richiesta.

Place thumb on the tab located at the back of the phone and slide button towards your hand and away from phone. While holding down the button, pull cover off with other hand. While holding down the button, pull cover off with other hand.
  • Place thumb on the tab located at the back of the phone and slide button towards your hand and away from phone.

  • While holding down the button, pull cover off with other hand.

Aggiungi Commento

Use fingers to grip the battery and remove it from the phone. Use fingers to grip the battery and remove it from the phone. Use fingers to grip the battery and remove it from the phone.
  • Use fingers to grip the battery and remove it from the phone.

Aggiungi Commento

Using a spudger, remove the four rubber coverings on the lower back plate.
  • Using a spudger, remove the four rubber coverings on the lower back plate.

Aggiungi Commento

Guida ai regali per la festa del papà
Facciamo onore non solo ai nostri padri — festeggiamo tutti i mentori che ci hanno insegnato a riparare.
Guida ai regali per la festa del papà
Facciamo onore a chi ci ha insegnato a riparare.
Using a Tri-wing Y0 screwdriver, remove the four 4.4mm screws securing the back plate. Using a Tri-wing Y0 screwdriver, remove the four 4.4mm screws securing the back plate. Using a Tri-wing Y0 screwdriver, remove the four 4.4mm screws securing the back plate.
  • Using a Tri-wing Y0 screwdriver, remove the four 4.4mm screws securing the back plate.

Aggiungi Commento

Remove the lower back cover to reveal part of the motherboard and the circular speaker housed in the back cover plate. Remove the lower back cover to reveal part of the motherboard and the circular speaker housed in the back cover plate. Remove the lower back cover to reveal part of the motherboard and the circular speaker housed in the back cover plate.
  • Remove the lower back cover to reveal part of the motherboard and the circular speaker housed in the back cover plate.

Aggiungi Commento

Unscrew the 4.4mm screws at the top of the phone with the Tri-wing Y0 Screwdriver. Unscrew the 4.4mm screws at the top of the phone with the Tri-wing Y0 Screwdriver.
  • Unscrew the 4.4mm screws at the top of the phone with the Tri-wing Y0 Screwdriver.

Aggiungi Commento

For the following steps, the phone is shown closed to make manipulating the parts easier. Using a spudger, remove the thin aluminum plate to access the upper motherboard. This will most likely be difficult to pry off and will take a considerable amount of force.  Stay clear of the piece to avoid injury when it comes free of the device.
  • For the following steps, the phone is shown closed to make manipulating the parts easier.

  • Using a spudger, remove the thin aluminum plate to access the upper motherboard.

    • This will most likely be difficult to pry off and will take a considerable amount of force. Stay clear of the piece to avoid injury when it comes free of the device.

Aggiungi Commento

Use the flat end of the spudger to remove two ribbon cables from the back of the motherboard.
  • Use the flat end of the spudger to remove two ribbon cables from the back of the motherboard.

Aggiungi Commento

Open the phone and firmly hold the phone casing with one hand and push the motherboard out of the case with the other by pushing on the keys. Once the keys are free from the casing, close the phone and pull the motherboard from the back of the phone the remainder of the way with your fingers. Once the keys are free from the casing, close the phone and pull the motherboard from the back of the phone the remainder of the way with your fingers.
  • Open the phone and firmly hold the phone casing with one hand and push the motherboard out of the case with the other by pushing on the keys.

  • Once the keys are free from the casing, close the phone and pull the motherboard from the back of the phone the remainder of the way with your fingers.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

StephenYH

Membro da: 11/03/2013

20 Reputazione

6 Guide realizzate

Team

Clemson, Team 12-1, Benson Spring 2013 Membro di Clemson, Team 12-1, Benson Spring 2013

CLEM-BENSON-S13S12G1

4 Membri

20 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 3

Tutti i Tempi: 268