Introduzione

This guide will provide a step-by-step procedure for replacing the keyboard in your Samsung Rogue.

Parti

Nessuna parte richiesta.

Before disassembling your Samsung Rogue, make sure it is powered off. With your thumbs, push down on the back cover of your phone and slide it away from the camera.
  • Before disassembling your Samsung Rogue, make sure it is powered off.

  • With your thumbs, push down on the back cover of your phone and slide it away from the camera.

Aggiungi Commento

You can now remove the battery by prying it up with your finger. You can now remove the battery by prying it up with your finger.
  • You can now remove the battery by prying it up with your finger.

Aggiungi Commento

Use a plastic opening tool to carefully pry the back cover surrounding the camera up from the phone.
  • Use a plastic opening tool to carefully pry the back cover surrounding the camera up from the phone.

Aggiungi Commento

Remove the five 3.4mm Philips screws securing the backing of the phone.
  • Remove the five 3.4mm Philips screws securing the backing of the phone.

Aggiungi Commento

Use a plastic opening tool to carefully pry off the back cover. Make sure you are prying along the edge and not between the two halves of the phone that slide away from each other. Be careful to not drop the volume changing piece, for it can easily slip out.
  • Use a plastic opening tool to carefully pry off the back cover.

  • Make sure you are prying along the edge and not between the two halves of the phone that slide away from each other.

  • Be careful to not drop the volume changing piece, for it can easily slip out.

Aggiungi Commento

Remove the two 3.45 mm Philips screws below the white sticker.
  • Remove the two 3.45 mm Philips screws below the white sticker.

Aggiungi Commento

Carefully lift the motherboard up from the bottom edge. The film of wires is still attached to the motherboard, so do not completely remove the motherboard just yet or you may damage it.
  • Carefully lift the motherboard up from the bottom edge.

  • The film of wires is still attached to the motherboard, so do not completely remove the motherboard just yet or you may damage it.

Aggiungi Commento

Use a plastic opening tool to disconnect the film from the motherboard. Use a plastic opening tool to disconnect the film from the motherboard.
  • Use a plastic opening tool to disconnect the film from the motherboard.

Aggiungi Commento

Remove the eight 1.7mm Philips screws above the keyboard.
  • Remove the eight 1.7mm Philips screws above the keyboard.

Aggiungi Commento

Carefully remove keyboard holder from the slider mechanisms underneath.
  • Carefully remove keyboard holder from the slider mechanisms underneath.

Aggiungi Commento

Turn keyboard holder over and allow the keyboard to simply fall out into your hand. Turn keyboard holder over and allow the keyboard to simply fall out into your hand.
  • Turn keyboard holder over and allow the keyboard to simply fall out into your hand.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Team

Cal Poly, Team 7-32, Maness Spring 2012 Membro di Cal Poly, Team 7-32, Maness Spring 2012

CPSU-MANESS-S12S7G32

4 Membri

16 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 3

Tutti i Tempi: 218