Introduzione

This guide will require the user to disassemble the rear and top panel to access the button.

Parti

Nessuna parte richiesta.

Remove the hinged top panel by taking the small pins at the bottom of the panel out of their holes. Remove the hinged top panel by taking the small pins at the bottom of the panel out of their holes. Remove the hinged top panel by taking the small pins at the bottom of the panel out of their holes.
  • Remove the hinged top panel by taking the small pins at the bottom of the panel out of their holes.

Aggiungi Commento

Using a Phillips #2 screwdriver, remove the four 1" long, Phillips, PH#2  screws on the back of the printer.
  • Using a Phillips #2 screwdriver, remove the four 1" long, Phillips, PH#2 screws on the back of the printer.

Aggiungi Commento

Gently lift the top panel while simultaneously pulling off the back panel. Before pulling out the back panel entirely, make sure to remove the rear cooling fan from its slot. Before pulling out the back panel entirely, make sure to remove the rear cooling fan from its slot.
  • Gently lift the top panel while simultaneously pulling off the back panel.

  • Before pulling out the back panel entirely, make sure to remove the rear cooling fan from its slot.

Aggiungi Commento

Remove front panel by gently moving the holes on the panel from the pegs attached to the main printer body, one at a time. Remove front panel by gently moving the holes on the panel from the pegs attached to the main printer body, one at a time. Remove front panel by gently moving the holes on the panel from the pegs attached to the main printer body, one at a time.
  • Remove front panel by gently moving the holes on the panel from the pegs attached to the main printer body, one at a time.

Aggiungi Commento

Using a Phillips #2 screwdriver, remove the two, 1", Phillips, PH#2 screws on the front face of the printer.
  • Using a Phillips #2 screwdriver, remove the two, 1", Phillips, PH#2 screws on the front face of the printer.

Aggiungi Commento

Using a plastic opening tool, gently lift one side of the top panel from its peg. Repeat for the other side. Lift the top panel from the front to remove entirely.
  • Using a plastic opening tool, gently lift one side of the top panel from its peg.

  • Repeat for the other side.

  • Lift the top panel from the front to remove entirely.

  • Turn over the top panel to reveal the underside, revealing the button.

Aggiungi Commento

Using a Phillips #2 screwdriver, remove the two, 1", Phillips, PH#2 screws from the underside of the top panel
  • Using a Phillips #2 screwdriver, remove the two, 1", Phillips, PH#2 screws from the underside of the top panel

Aggiungi Commento

Remove the clear plastic piece and the orange button from the panel. Remove the orange button and the spring from the clear plastic piece.
  • Remove the clear plastic piece and the orange button from the panel.

  • Remove the orange button and the spring from the clear plastic piece.

  • Replace the button and reassemble the printer following the directions in reverse order.

Aggiungi Commento

Linea Traguardo

Un'altra persona ha completato questa guida.

bbaustin

Membro da: 12/10/2011

199 Reputazione

6 Guide realizzate

Team

Cal Poly, Team 17-18, Regan Fall 2011 Membro di Cal Poly, Team 17-18, Regan Fall 2011

CPSU-REGAN-F11S17G18

4 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 14

Tutti i Tempi: 2,304