Parti

Nessuna parte richiesta.

Lay the TV screen-side down on a flat, soft surface.
  • Lay the TV screen-side down on a flat, soft surface.

  • Remove four Phillips screws attaching the stand to the TV.

Aggiungi Commento

  • Slide the stand out from the bottom of the TV.

Aggiungi Commento

Remove fifteen Phillips screws securing the rear case to the front. If present, remove four Phillips screws for the VESA mount.
  • Remove fifteen Phillips screws securing the rear case to the front.

  • If present, remove four Phillips screws for the VESA mount.

  • Carefully lift the rear case upwards to separate it from the frame of the TV.

Aggiungi Commento

The Timing Controller (T-Con) board is located at the top center behind a metal shield. Remove four Phillips screws.
  • The Timing Controller (T-Con) board is located at the top center behind a metal shield.

  • Remove four Phillips screws.

  • Tilt the metal shield towards the top of the TV and lift away.

Aggiungi Commento

Disconnect the two ribbon cables at the top by flipping up the retaining flaps and sliding the ribbons straight up towards the top of the TV.
  • Disconnect the two ribbon cables at the top by flipping up the retaining flaps and sliding the ribbons straight up towards the top of the TV.

Aggiungi Commento

Disconnect the bottom ribbon cable by depressing the two buttons on either side of the connector and sliding down towards the bottom of the TV.
  • Disconnect the bottom ribbon cable by depressing the two buttons on either side of the connector and sliding down towards the bottom of the TV.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Steven Carlton

Membro da: 19/08/2013

534 Reputazione

3 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 8

Ultimi 30 Giorni: 61

Tutti i Tempi: 7,784