Introduzione

How-to-guide for replacing the Samsung Juke SCH-u470 camera/speaker.

Locate the button on the bottom of the phone. Once located, press and hold the button down.
  • Locate the button on the bottom of the phone. Once located, press and hold the button down.

Aggiungi Commento

While holding the button down, remove the back cover of the phone. While holding the button down, remove the back cover of the phone.
  • While holding the button down, remove the back cover of the phone.

Aggiungi Commento

Use the size 00 Phillips screwdriver to remove the four screws located on the back of the phone. These screws are circled in yellow in the given image.
  • Use the size 00 Phillips screwdriver to remove the four screws located on the back of the phone. These screws are circled in yellow in the given image.

Aggiungi Commento

Using the same 00 Phillips screwdriver, remove the two screws at the bottom back plate of the phone near the camera and the speaker.
  • Using the same 00 Phillips screwdriver, remove the two screws at the bottom back plate of the phone near the camera and the speaker.

  • These screws will be 7.25 mm long.

Aggiungi Commento

Before proceeding, locate the USB port (where the charger can be plugged in) and open it using the iFixit Opening Tool. Failure to open USB port cover at this stage may result in damaging the device. Failure to open USB port cover at this stage may result in damaging the device.
  • Before proceeding, locate the USB port (where the charger can be plugged in) and open it using the iFixit Opening Tool.

  • Failure to open USB port cover at this stage may result in damaging the device.

Aggiungi Commento

Remove the screws on either side of the camera/speaker with a Phillips 00 screwdriver.
  • Remove the screws on either side of the camera/speaker with a Phillips 00 screwdriver.

  • These screws will be 5.45 mm long.

Aggiungi Commento

Use the iFixit Opening Tool to begin removing the camera/speaker from the logic board. Practice caution to prevent damage to the attaching ribbon.
  • Use the iFixit Opening Tool to begin removing the camera/speaker from the logic board.

  • Practice caution to prevent damage to the attaching ribbon.

Aggiungi Commento

To completely remove the camera/speaker, locate the orange attachment beneath it (as shown in the image). Then, use the iFixit Opening Tool to gently pry the camera/speaker off.
  • To completely remove the camera/speaker, locate the orange attachment beneath it (as shown in the image).

  • Then, use the iFixit Opening Tool to gently pry the camera/speaker off.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Renee Kuzniar

Membro da: 13/04/2010

82 Reputazione

8 Guide realizzate

Team

Cal Poly, Team 6-18, Maness Spring 2010 Membro di Cal Poly, Team 6-18, Maness Spring 2010

CPSU-MANESS-S10S6G18

3 Membri

12 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 4

Ultimi 30 Giorni: 4

Tutti i Tempi: 3,301