Introduzione

This guide will provide a step by step procedure for installing the camera.

Parti

Nessuna parte richiesta.

Using your thumb, press down and slide the back cover away from the  camera.
  • Using your thumb, press down and slide the back cover away from the camera.

Aggiungi Commento

Remove the battery from the phone.
  • Remove the battery from the phone.

Aggiungi Commento

Using a Phillips#00 screw driver, remove the six 4mm screws holding the back case together. Using a Phillips#00 screw driver, remove the six 4mm screws holding the back case together.
  • Using a Phillips#00 screw driver, remove the six 4mm screws holding the back case together.

Aggiungi Commento

Use a  plastic opening tool to pry the case off. To do this, find a gap on any side of the phone, top preferably, and slip the tip of the tool in the gap Now use moderate strength and slowly maneuver the tool around the outside until the case becomes loose.
  • Use a plastic opening tool to pry the case off. To do this, find a gap on any side of the phone, top preferably, and slip the tip of the tool in the gap

  • Now use moderate strength and slowly maneuver the tool around the outside until the case becomes loose.

  • Using your fingers, take the case off.

Aggiungi Commento

The green film above the camera is the camera connector to the motherboard. Use a plastic opening tool to disconnect the camera connector.
  • The green film above the camera is the camera connector to the motherboard.

  • Use a plastic opening tool to disconnect the camera connector.

Aggiungi Commento

The golden film connector connects the keyboard to the motherboard. Use a plastic opening tool to disconnect the keyboard connector.
  • The golden film connector connects the keyboard to the motherboard.

  • Use a plastic opening tool to disconnect the keyboard connector.

Aggiungi Commento

The circular connector holds the motherboard in place. Using a plastic opening tool, disconnect the circular connector.
  • The circular connector holds the motherboard in place.

  • Using a plastic opening tool, disconnect the circular connector.

Aggiungi Commento

There is a LCD connector underneath the motherboard. Gently lift the far edge of the motherboard upwards toward the center of the phone. Using a plastic opening tool, disconnect the LCD connector.
  • There is a LCD connector underneath the motherboard.

  • Gently lift the far edge of the motherboard upwards toward the center of the phone.

  • Using a plastic opening tool, disconnect the LCD connector.

Aggiungi Commento

After disconnecting the four connectors, gently lift the motherboard up with your fingers. Place the motherboard in a secure area.
  • After disconnecting the four connectors, gently lift the motherboard up with your fingers.

  • Place the motherboard in a secure area.

Aggiungi Commento

Use your thumb and index finger to grip the camera connector. Pull the camera connector upwards to detach the camera.
  • Use your thumb and index finger to grip the camera connector.

  • Pull the camera connector upwards to detach the camera.

  • The camera was glued on, so this may require moderate strength.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Cameron Law

Membro da: 12/10/2011

142 Reputazione

10 Guide realizzate

Team

Cal Poly, Team 3-12, Regan Fall 2011 Membro di Cal Poly, Team 3-12, Regan Fall 2011

CPSU-REGAN-F11S3G12

4 Membri

14 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 4

Tutti i Tempi: 786