Introduzione

Follow these steps if you are experiencing uneven print quality or lines in your printed documents.

Turn the printer off and wait a few minutes for it to cool.
  • Turn the printer off and wait a few minutes for it to cool.

Aggiungi Commento

Pull paper tray out and set aside.
  • Pull paper tray out and set aside.

Aggiungi Commento

Open the front cover. Open the front cover.
  • Open the front cover.

Aggiungi Commento

Pull the waste toner container out of the printer using the handle.
  • Pull the waste toner container out of the printer using the handle.

  • Make sure to keep waste toner container upright to avoid spillage.

Aggiungi Commento

Pull the imaging unit out of the printer using bottom handle. Use green handle on top of imaging unit to steady unit as you pull it out. At this point you can set the printer aside as you will only need the imaging unit to continue repair.
  • Pull the imaging unit out of the printer using bottom handle.

  • Use green handle on top of imaging unit to steady unit as you pull it out.

  • At this point you can set the printer aside as you will only need the imaging unit to continue repair.

Aggiungi Commento

Remove these two screws. Do not expose imaging unit to light for more than a few minutes. Covering unit with a piece of paper is sufficient protection while you complete repair.
  • Remove these two screws.

  • Do not expose imaging unit to light for more than a few minutes. Covering unit with a piece of paper is sufficient protection while you complete repair.

Aggiungi Commento

Carefully pry plastic arm away from main unit.
  • Carefully pry plastic arm away from main unit.

Aggiungi Commento

Carefully pry plastic from screw base so that the entire organic photo conductor piece slides open to the left. When removing the organic photo conductor take care to not lose the small spring on the back left. At this point you may want to put on plastic gloves to keep from staining hands with printer ink.
  • Carefully pry plastic from screw base so that the entire organic photo conductor piece slides open to the left.

  • When removing the organic photo conductor take care to not lose the small spring on the back left.

  • At this point you may want to put on plastic gloves to keep from staining hands with printer ink.

Aggiungi Commento

Slide each toner transfer unit out separately, placing all aside except for the black toner transfer unit. Keep toner rollers level to avoid toner spillage.
  • Slide each toner transfer unit out separately, placing all aside except for the black toner transfer unit.

  • Keep toner rollers level to avoid toner spillage.

Aggiungi Commento

Remove these five screws from the top of the black toner transfer unit. Remove main and smaller z-shaped plates. Remove main and smaller z-shaped plates.
  • Remove these five screws from the top of the black toner transfer unit.

  • Remove main and smaller z-shaped plates.

Aggiungi Commento

Remove these three screws from the right end of the toner transfer unit. Remove these three screws from the right end of the toner transfer unit.
  • Remove these three screws from the right end of the toner transfer unit.

Aggiungi Commento

Remove plastic end piece.
  • Remove plastic end piece.

  • Gently pull out black toner roller.

  • Insert new roller in place of old roller turning slightly to fit.

  • Be careful not to pinch small foam square when inserting new roller.

  • Cover new roller with toner by rotating roller by hand.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Heather Howard

Membro da: 15/10/2014

439 Reputazione

4 Guide realizzate

Team

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 19

Tutti i Tempi: 1,427