Introduzione

Use this guide to replace the back casing and to remove the back casing to access the interior of the phone.

Apply downward pressure to the top of the battery panel while pulling down to slide it off the phone. Apply downward pressure to the top of the battery panel while pulling down to slide it off the phone. Apply downward pressure to the top of the battery panel while pulling down to slide it off the phone.
  • Apply downward pressure to the top of the battery panel while pulling down to slide it off the phone.

Aggiungi Commento

Locate the grooves on the sides of the battery near the bottom of the phone. Use your fingers to pull the battery up and out of the phone. Locate the grooves on the sides of the battery near the bottom of the phone. Use your fingers to pull the battery up and out of the phone. Locate the grooves on the sides of the battery near the bottom of the phone. Use your fingers to pull the battery up and out of the phone.
  • Locate the grooves on the sides of the battery near the bottom of the phone. Use your fingers to pull the battery up and out of the phone.

Aggiungi Commento

Use the spudger to pry the two plastic caps out of the top corners of the phone casing. To get a better grip, you may use the tweezers to finish pulling the plastic caps from the phone.
  • Use the spudger to pry the two plastic caps out of the top corners of the phone casing.

  • To get a better grip, you may use the tweezers to finish pulling the plastic caps from the phone.

Aggiungi Commento

Remove the six 4.0 mm screws using the Phillips 00 screwdriver.
  • Remove the six 4.0 mm screws using the Phillips 00 screwdriver.

Aggiungi Commento

Insert the plastic opening tool in the gap between the back panel and rest of the body. Slide the tool along the edges until the two pieces come apart. The circuit board is attached to the front casing. Both casings should separate without having to sever electrical connections.
  • Insert the plastic opening tool in the gap between the back panel and rest of the body.

  • Slide the tool along the edges until the two pieces come apart.

  • The circuit board is attached to the front casing. Both casings should separate without having to sever electrical connections.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Ryan Rumsey

Membro da: 30/01/2013

8 Reputazione

6 Guide realizzate

Team

Cal Poly, Team 20-1, Maness Winter 2013 Membro di Cal Poly, Team 20-1, Maness Winter 2013

CPSU-MANESS-W13S20G1

4 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 238