Introduzione

This guide will be showing step-by-step instructions on how to get to and replace the barrel of the airsoft gun.

Parti

Nessuna parte richiesta.

Using a flathead screwdriver, remove the pin holding the hand guard in place. To remove this, turn the pin clockwise and push it through at the same time.
  • Using a flathead screwdriver, remove the pin holding the hand guard in place.

    • To remove this, turn the pin clockwise and push it through at the same time.

  • Pull the hand guard off.

Aggiungi Commento

Using a Phillips #1 screwdriver, remove the two 8mm screws above the hand guard on both sides of the gun. There should be four total. Using a Phillips #1 screwdriver, remove the two 8mm screws above the hand guard on both sides of the gun. There should be four total.
  • Using a Phillips #1 screwdriver, remove the two 8mm screws above the hand guard on both sides of the gun. There should be four total.

Aggiungi Commento

Locate the button to fold over the folding stock and fold over the folding stock. Using a Phillips #1 screwdriver, remove the 20mm screw located behind the folding stock.
  • Locate the button to fold over the folding stock and fold over the folding stock.

  • Using a Phillips #1 screwdriver, remove the 20mm screw located behind the folding stock.

Aggiungi Commento

Kit RAM Mac
Accelera il Mac. Porta la memoria al massimo.
Kit RAM Mac
Metti più memoria nel tuo Mac.
Turn the gun over so that you are facing the bottom of the gun. Using a Phillips #1 screwdriver, remove the following screws:
  • Turn the gun over so that you are facing the bottom of the gun.

    • Using a Phillips #1 screwdriver, remove the following screws:

      • Remove the 8mm screw located directly underneath the cocking lever.

      • Remove the 8mm screw beside the one you just removed.

Aggiungi Commento

Carefully tug on the tip of the gun and pull the barrel and its cover out. Carefully tug on the tip of the gun and pull the barrel and its cover out.
  • Carefully tug on the tip of the gun and pull the barrel and its cover out.

Aggiungi Commento

Pull the barrel out from the cover. Remove the pieces at the end of the barrel. Remove the pieces at the end of the barrel.
  • Pull the barrel out from the cover.

  • Remove the pieces at the end of the barrel.

Aggiungi Commento

Remove the remaining pieces of on the ends of the barrel. Remove the remaining pieces of on the ends of the barrel.
  • Remove the remaining pieces of on the ends of the barrel.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Laura Schulz

Membro da: 05/10/2012

1 Reputazione

1 Guida realizzata

Team

Cal Poly, Team 18-41, Regan Fall 2012 Membro di Cal Poly, Team 18-41, Regan Fall 2012

CPSU-REGAN-F12S18G41

6 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 11

Tutti i Tempi: 1,085