Introduzione

Removing and replacing the DVD-ROM drive.

Parti

Nessuna parte richiesta.

Pull on outer latch. Lower door until it is level with your work surface.
  • Pull on outer latch.

  • Lower door until it is level with your work surface.

  • Before working on the computer make sure it is not plugged into a power supply, then touch a metal object. This discharges static electricity, which could damage the computer.

Aggiungi Commento

Removing the faceplate. On the inside of the case, find the two plastic tabs.
  • Removing the faceplate.

    • On the inside of the case, find the two plastic tabs.

    • While depressing the tabs, remove the faceplate by pulling and rotating outward.

Aggiungi Commento

Remove the two screws on the front of the drive with the Phillips #1 screwdriver.
  • Remove the two screws on the front of the drive with the Phillips #1 screwdriver.

Aggiungi Commento

Pull the drive out to allow access to the power and ribbon cables. Do not fully remove. Remove both the power and ribbon cable. Remove both the power and ribbon cable.
  • Pull the drive out to allow access to the power and ribbon cables. Do not fully remove.

  • Remove both the power and ribbon cable.

Aggiungi Commento

Linea Traguardo

Altre 23 persone hanno completato questa guida.

Justin Petrilli

Membro da: 21/01/2010

2.598 Reputazione

11 Guide realizzate

Team

Cal Poly, Team 13-24, Maness Winter 2010 Membro di Cal Poly, Team 13-24, Maness Winter 2010

CPSU-MANESS-W10S13G24

4 Membri

13 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 28

Tutti i Tempi: 8,376