Introduzione

Use this guide to open the dock and install other components.

Parti

Nessuna parte richiesta.

Pry off the four white feet with the pointed end of the spudger
  • Pry off the four white feet with the pointed end of the spudger

Aggiungi Commento

Unscrew the four 15.5 mm Phillips #2 screws that hold the bottom panel to the dock.
  • Unscrew the four 15.5 mm Phillips #2 screws that hold the bottom panel to the dock.

Aggiungi Commento

Use the flat end of the spudger to pry the lid off from the two connectors holding it to the body of the dock.
  • Use the flat end of the spudger to pry the lid off from the two connectors holding it to the body of the dock.

  • The connectors on the panel are fragile and may break.

Aggiungi Commento

Carefully pull up and out the four electrical connectors and the two ribbon connectors connecting the bottom panel and the dock. Electrical Connectors Ribbon Connectors
  • Carefully pull up and out the four electrical connectors and the two ribbon connectors connecting the bottom panel and the dock.

    • Electrical Connectors

    • Ribbon Connectors

  • The cables do not have a lot of slack in them. Be careful not to break the connectors.

  • One wire is soldered onto the bottom panel. Be careful not to break this bond.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Greg Lane

Membro da: 16/04/2013

9 Reputazione

4 Guide realizzate

Team

Cal Poly, Team 3-48, Amido Spring 2013 Membro di Cal Poly, Team 3-48, Amido Spring 2013

CPSU-AMIDO-S13S3G48

4 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 199