Introduzione

Use for a diagnosed wiring problem.

Parti

Nessuna parte richiesta.

Using a Torx T20 screwdriver, remove the four screws attaching the back plate. Using a Torx T20 screwdriver, remove the four screws attaching the back plate.
  • Using a Torx T20 screwdriver, remove the four screws attaching the back plate.

Aggiungi Commento

Remove the five screws attaching the drill handle.
  • Remove the five screws attaching the drill handle.

Aggiungi Commento

Remove the 4 screws attaching the front of the casing. Remove the 4 screws attaching the front of the casing.
  • Remove the 4 screws attaching the front of the casing.

Aggiungi Commento

Use a multimeter set above 18V DC to check electrical connections where wires meet drill, switch, or battery terminal.
  • Use a multimeter set above 18V DC to check electrical connections where wires meet drill, switch, or battery terminal.

Aggiungi Commento

Look for corrosion or burnt wires.
  • Look for corrosion or burnt wires.

  • If there are any bad connections or if there is visible damage, replace damaged wire and solder.

Aggiungi Commento

  • After soldering sand off jaged solder then wrap with electrical tape

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Evan Long

Membro da: 15/04/2010

232 Reputazione

4 Guide realizzate

Team

Cal Poly, Team 15-48, Garner Spring 2010 Membro di Cal Poly, Team 15-48, Garner Spring 2010

CPSU-GARNER-S10S15G48

6 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 5

Ultimi 30 Giorni: 33

Tutti i Tempi: 3,949