Introduzione

Installing the video card involves removing the outer case before actual installation.

Parti

Nessuna parte richiesta.

Release the back handle of the PowerMac. Slowly pull out the cube by holding the end of the handle. Watch for any parts that may become entangled with the outer case. Push back the handle after you have taken the core out of the case. Push back the handle after you have taken the core out of the case.
  • Release the back handle of the PowerMac. Slowly pull out the cube by holding the end of the handle. Watch for any parts that may become entangled with the outer case.

  • Push back the handle after you have taken the core out of the case.

Aggiungi Commento

Place the cube upside down and remove the four T10 Torx screws on the front plate. Then remove the two screws on each side. Place the cube upside down and remove the four T10 Torx screws on the front plate. Then remove the two screws on each side.
  • Place the cube upside down and remove the four T10 Torx screws on the front plate. Then remove the two screws on each side.

Aggiungi Commento

Slowly lift the plate off the cube and disconnect the power cord.
  • Slowly lift the plate off the cube and disconnect the power cord.

Aggiungi Commento

Remove the four pillars from each corner.
  • Remove the four pillars from each corner.

  • The pillars should come out fairly easily.

If the Cube has an Airport card installed, it must be removed. This can be accomplished by disconnecting its antenna, and pulling gently on the clear plastic tab on its end. The bracket it is contained in must be unlatched from the frame and rotated out of the way to get to the two optical drive mounting screws beneath it.

olearydq - Replica

There is a ribbed cooling plate attached to the hard drive that must be removed before step 7.

isitism - Replica

There is no need to remove the four pillars. Skip step 4. In step 5, don't turn the Cube on it's side. The Airport slot swings out like a door, providing access to the IDE ribbon and power cables to complete step 6. Complete steps 6 and 7 while the cube is upright.

timhood - Replica

Remove the screws on the back of the VGA port.
  • Remove the screws on the back of the VGA port.

Aggiungi Commento

Remove the screw attaching the video card to the logic board.
  • Remove the screw attaching the video card to the logic board.

Aggiungi Commento

Remove power cord from the video card. Remove power cord from the video card.
  • Remove power cord from the video card.

Aggiungi Commento

Remove the power cord.
  • Remove the power cord.

  • Remove the connector.

  • Remove the video card from the logic board.

Aggiungi Commento

Carefully lift the video card from the logic board.
  • Carefully lift the video card from the logic board.

  • The video card should come out easily.

Aggiungi Commento

Separate the video card from the adapter. Separate the video card from the adapter.
  • Separate the video card from the adapter.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 6 persone hanno completato questa guida.

Ryan Chun

Membro da: 24/06/2010

674 Reputazione

7 Guide realizzate

Team

Cal Poly, Team 2-7, Johann Summer 2010 Membro di Cal Poly, Team 2-7, Johann Summer 2010

CPSU-JOHANN-R10S2G7

5 Membri

7 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 8

Ultimi 30 Giorni: 31

Tutti i Tempi: 8,533